What did you do TO / WITH your Bronco today? 👨🏻‍🔧🧰🚿🛠

Bee Bop · Dec 3, 2023

Worked on the mtx275 install I got the antenna and radio mounted. I just use the cig adapter to test it. I still have to wire it up to an up-fitter switch and figure out a mic mount solution. I am not too happy with the antenna wire work I may redo it.

Ford Bronco What did you do TO / WITH your Bronco today? 👨🏻‍🔧🧰🚿🛠 image0

Ford Bronco What did you do TO / WITH your Bronco today? 👨🏻‍🔧🧰🚿🛠 image1

Ford Bronco What did you do TO / WITH your Bronco today? 👨🏻‍🔧🧰🚿🛠 image4

Ford Bronco What did you do TO / WITH your Bronco today? 👨🏻‍🔧🧰🚿🛠 image3

Ford Bronco What did you do TO / WITH your Bronco today? 👨🏻‍🔧🧰🚿🛠 image2

Dude1967 · Dec 3, 2023

Ford Bronco What did you do TO / WITH your Bronco today? 👨🏻‍🔧🧰🚿🛠 20231203_100048

CarbonSteel · Dec 3, 2023

Installed a set of Redline Tuning hood lifts--easy peasy. Grabbed them in a BF special for $50. Great price and totally worth it. I had these on my Wrangler and they were great.

Wanted to change the rear axle fluid again and install a Ford Performance axle cover and change the transfer case fluid again, but the day got away. There's always next weekend.

Ford Bronco What did you do TO / WITH your Bronco today? 👨🏻‍🔧🧰🚿🛠 20231203_155008

cr117 · Dec 3, 2023

Built a platform for our dogs when going on a road trip. The cargo area is usually full of all our other gear, so I wanted a nice, stable place for the dogs to sleep. Just need to glue on some rubber mats to keep them from sliding around.

Ford Bronco What did you do TO / WITH your Bronco today? 👨🏻‍🔧🧰🚿🛠 IMG_0910

Ford Bronco What did you do TO / WITH your Bronco today? 👨🏻‍🔧🧰🚿🛠 IMG_0912

Fordified1 · Dec 3, 2023

GroovyGeek said:
Why do people find auto start stop annoying? Honest question, I have it and just ignore it. Does it wear out the battery prematurely?

Wear and tear on the starter and flywheel teeth. If you have a weak battery it could leave you stranded at a light. But most people don’t keep their vehicles long enough to matter. It flat annoys me, because I’m not used to it. Disabled on my Jeep.

Oh, and it’s just stupid.

CUPRA · Dec 3, 2023

Did a test fit of the Warn VR EVO 10 winch on the Mabett winch mount. I’ve read that people had issues with it fitting but so far all looks to be good!

Ford Bronco What did you do TO / WITH your Bronco today? 👨🏻‍🔧🧰🚿🛠 IMG_7316

Ford Bronco What did you do TO / WITH your Bronco today? 👨🏻‍🔧🧰🚿🛠 IMG_7320

Ford Bronco What did you do TO / WITH your Bronco today? 👨🏻‍🔧🧰🚿🛠 IMG_7319

Ford Bronco What did you do TO / WITH your Bronco today? 👨🏻‍🔧🧰🚿🛠 IMG_7317

Ford Bronco What did you do TO / WITH your Bronco today? 👨🏻‍🔧🧰🚿🛠 IMG_7318

Dorf2point0 · Dec 3, 2023

Finally found the oil pressure sensor switch location on the 2.7 L …. Yeah! This is import to pull oil for by-pass filtration.. That oil filter cartridge is just too small. Look

low on the passenger side of the engine.. It’s easy access..

Ford Bronco What did you do TO / WITH your Bronco today? 👨🏻‍🔧🧰🚿🛠 IMG_9209

Ford Bronco What did you do TO / WITH your Bronco today? 👨🏻‍🔧🧰🚿🛠 IMG_9207

Ford Bronco What did you do TO / WITH your Bronco today? 👨🏻‍🔧🧰🚿🛠 IMG_9210

BeerRunner · Dec 4, 2023

Ford Bronco What did you do TO / WITH your Bronco today? 👨🏻‍🔧🧰🚿🛠 IMG_1224

Ford Bronco What did you do TO / WITH your Bronco today? 👨🏻‍🔧🧰🚿🛠 IMG_1211

Downgraded (yes you read that right) my rear OEM steel bumper to a @HavocOffroad steel bender..so many issues with this thing, from wrong hardware sent, to incorrect instructions for parking sensors, to light cutouts being larger than advertised. Anyways it’s on with 5 of the 6 bolts, and wired up for flood lights. I’m going to use the @StickerFab magic reverse light kit so they light with reverse and on demand via aux.

Also added

-rough country 87 series wheels

-Havoc hitch

-rough country tailgate reinforcement (not relocation) and added an old ACU Molle sustainment pouch to it.

-DV8 license plate bracket. Great quality with the design, supposed Ford didn’t come up with that idea