Valve Stem Extenders for SAS Wheels

[Canyon Coolers]

I don't like extensions at all, but I really struggle to get an air hose (or my Morrflate system) on the valve stems. I guess I could have longer stems installed, but that seems like it would be expensive. Several of my trim rings are nicked (could have been the previous owner) where the tool goes on the stem as well. What is everyone else doing? Just struggling and getting accessories screwed onto the stems?

I really like the Apex deflators. They extend the valve stem just enough and make air down super easy.

Sponsored

 

[thompsdw]

I am looking for the same but need it to angle out away from the rim not much space to get the Moorflate quick connect on the stem.

The idea I have it to get the valve out past the wheel. Then you can do whatever you want.

 

[userdude]

I used my MORRFlate kit this weekend and found if I put my thumb between the chuck and the wheel, and have the line depressurized, and tilt it away maybe a quarter of an inch, all four came off easily with just a tug. This was after a minute struggling with it using other grips. So yeah, I dunno. I still like the idea of putting the extension on the hose end/chuck, but there's probably upsides to extending it on the tire side.

Sponsored