Off road light install

[RJ Bronco]

I want to install off road lights on my nudge bar. I have no factory aux switches. What is the best way to do this and what switch to get?

Sponsored

 

[PWillette]

Easiest would be to pull power directly from the battery then run the switch into the cabin. Purchase a complete kit w/ a fused wiring harness included and everything should be pretty much plug & play.

 

[SZairborne]

If you look at the different sponsors here that sell lights, they have all different configurations. I am in the same boat as you and essentially you need a controller to control all the lights.

 

[Silver-Bolt]

You could also add a control panel. Good idea if you plan to add other accessories.

https://www.4x4spod.com/products/vehicle_type/universal

 

[RJ Bronco]

Easiest would be to pull power directly from the battery then run the switch into the cabin. Purchase a complete kit w/ a fused wiring harness included and everything should be pretty much plug & play.

Thanks

 

[4x4TruckLEDs.com]

Check out our site at www.4x4TruckLEDs.com for lights. For a switch panel, we put one of these in our own bronco (the AuxBeam panels): https://www.4x4truckleds.com/installation-accessories/switches-harnesses/

 

[Theherofails]

I have the upfitters, but ran out. That left me with no choice but to use the factory switch panel that came with my lightbar.



I 3D printed a carbon fiber mount to allow me to angle the buttons down a bit. It's simple, but works great. It's mounted with Scotch extreme install tape and feels incredibly solid.

You could go with SwitchPros or something similar and mount it in about the same spot. It's a bit pricy though.

Sponsored