Modular bumper sensor hole plugs

[Kevink820]

For the people that have swapped the modular bumper with sensor holes to a bronco that doesn’t have front parking sensors. Where are you getting your sensor hole plugs.

Sponsored

 

[RagnarKon]

I use rubber grommets for stuff like this. The kit I bought came from Harbor Freight and it looks like they don't sell it anymore. But they are all over Amazon.

I've also seen people at Bronco meetups with 3d printed versions they printed themselves or bought form Etsy.

 

[HeliPilot]

I ordered a front parking sensor kit off Amazon for an aftermarket bumper I bought. The system has worked flawlessly for two years. You can see them in this closeup.

 

[HD1976]

I use rubber grommets for stuff like this. The kit I bought came from Harbor Freight and it looks like they don't sell it anymore. But they are all over Amazon.

I've also seen people at Bronco meetups with 3d printed versions they printed themselves or bought form Etsy.

I use rubber grommets for stuff like this. The kit I bought came from Harbor Freight and it looks like they don't sell it anymore. But they are all over Amazon.

I've also seen people at Bronco meetups with 3d printed versions they printed themselves or bought form Etsy.

do you know the dimension ms of the grommet you used? I have a guy that can probably 3D print or make a vinyl wrap for the grommet using color if you want and maybe throw a Sasquatch or Bronco on it for customization. I send you some if he is able!

 

[Ranbronc]

I bought a Rockhard 4x4 bumper it included plastic plugs in case you have a no sensor bumper.
measure the holes and check MSC direct or granger.

 

[VAtruck]

I got a set on Ebay for about fifteen bucks that worked great. They snap in and you can hardly see them. Rear Steel Bumper Sensor Hole Plugs 2021-2024 Ford Bronco *ALL 4* Inner & Outer

 

[KABQ]

do you know the dimension ms of the grommet you used? I have a guy that can probably 3D print or make a vinyl wrap for the grommet using color if you want and maybe throw a Sasquatch or Bronco on it for customization. I send you some if he is able!

You could always buy a replacement sensor to model your 3D printed plug after so it will lock in position, then return the sensor.

Sponsored