Modular bumper inner caps?

[thatboxcarguy]

Does anyone know if there is a manufacture that makes caps for the back side of the modular bumper to protect any fog lights from debris from the tires. I have a popular brand (not going to name drop because I don't think it was an issue with their quality) fog light kit and the finish on the lights corroded. Cleaned them up and resprayed them but I don't want them to corrode again. Searched but I couldn't find anything.

Sponsored

 

[Squirrel13]

Following. On my F350 that spot would fill with ice and snow. Ford had a part to fill that void. Be nice if someone had a similar part for tbe Bronco.

 

[dstanky]

Following.

 

[MadMan4BamaNATL]

Doubt it because on an off-roader think the idea would be for the space to be open to prevent things from getting trapped in there such as water, rocks, dust, twigs and so on.

Corrosion means the water seal likely isn’t good, so the quality brand part is questionable to me.

I will gladly name my Baja Designs fog array and they get put through the paces and no corrosion for mine and I installed and wired myself. At all connectors I did add weather electrical tape to wrap and I’m on 2+ years.

Think the OP should name the brand.

 

[GPPBronco]

Think the OP should name the brand.

Not until we tie them to the stake and stack the firewood at their feet, though!

 

[thatboxcarguy]

They are Baja Designs. They have been installed a little short of two years. The factory fog lights on a Bronco Raptor have a cover but it is specifically for that setup.

Sponsored