Introduction and Looking for Storage Solution ideas

[OverlandGearGuy]

Hi Everyone, Rob Daugherty with OverlandGearGuy.com I am new to the group, I specialize in Storage Solutions for Sprinter Type Vans, Jeeps, Tacoma's Jeep Gladiators.... and I am exploring what I can make for Bronco's

We have been manufacturing in the USA since 1990 (32 Years) and all our products have a Lifetime Workmanship Warranty.

If you have any needs / ideas for products I make, message me here or shoot me an email [email protected]

We specialize in Seat organizers, Tool Bags, Kitchen Utensil Bags, Spare Tire Trash / Recovery Gear Bags, Packing Cubes, MaxTrax Bags... Pretty much anything for the inside of the vehicle with the exception of the Spare Tire Bags.

I am looking for a bronco Owner in the Salt Lake, Utah area that I can use the Bronco for Product Development and Photo ops.


Thx for you time, looking forward to your ideas.

Rob Daugherty

Sponsored

 

[M&M Beer]

Make a roof top flat track rack
Can you fly to Michigan?

 

[Gabby]

You should pop over to the UT owner's group. I'm sure someone there will be a willing local test bed. Or you can contact This Just in with Justin B McBride. He's a former Jeep Duck turned Bronco Ambassador that lives in SLC. He's on here as well.

https://www.justinbmcbride.com/

https://youtube.com/@ThisJustInWithJustin

 

[JediMcMuffin]

well I'll give you some free ideas:

1) a base plate is kinda needed, the four tie-down points in the back leave a lot to be desired
2) the goose gear plate is excellent and thats what i went with, I was hesitant to buy american adventure labs system because i didn't like that it elevated the floor a little and i was sure over time it would rattle like crazy
3) the tuff/ford oem cargo security drawer wastes a TON of space both inside the drawer and out, don't do that
4) i think most of us will run the same setup, a fridge slide on the left, and some level of storage on the right so it would be good to look at what you already have and how best to fit it into that remaining space on the right.
5) i think having solutions that are removable for those of us who are daily drivers is important

i'll definitely be checking out your kit, thanks!

 

[JediMcMuffin]

You should pop over to the UT owner's group. I'm sure someone there will be a willing local test bed. Or you can contact This Just in with Justin B McBride. He's a former Jeep Duck turned Bronco Ambassador that lives in SLC. He's on here as well.

https://www.justinbmcbride.com/

https://youtube.com/@ThisJustInWithJustin

his bronco goes back to ford in a few weeks, hopefully hes a raptor ambassador next but im guessing nope

 

[Gabby]

his bronco goes back to ford in a few weeks, hopefully hes a raptor ambassador next but im guessing nope

He has a Bronco on order. Ford should just show up and do a 1:1 swap.

 

[OverlandGearGuy]

Make a roof top flat track rack
Can you fly to Michigan?

Well we only do Soft Goods, nothing out of metal of any kind, it would be nice to come to Michigan ;-)

 

[CptSamFalcon]

Im in WA but I'll keep an eye on you guys. Looking for storage solutions.

 

[OverlandGearGuy]

Im in WA but I'll keep an eye on you guys. Looking for storage solutions.

Sweet, thx. What part of WA. I used to live up in the PNW


Followed you on ig



http://Instagram.com/OverlandGearGuy

 

[CptSamFalcon]

Sweet, thx. What part of WA. I used to live up in the PNW


Followed you on ig



http://Instagram.com/OverlandGearGuy

I live in Covington - so just south of Seattle.

 

[Southern62]

In my 2003 Jeep I had plastic storage bins that went behind the seat (2 door so not much room but it was lockable and could be pulled out relatively easily), it filled the area entirely and allowed for locking storage when I had the top down or off. Think sorta like a Tuffy box that fits behind the 2 door rear seats and has a locking top (or side for rear access.)

 

[OverlandGearGuy]

Here is some great I recently made up for the Jeep Gladiators

https://overlandgearguy.com/collections/jeep-gladiator-gear. might give you some ideas

 

[Rspayde]

Come up with a solution for bug screens / vents on the frameless windows and you can have my money. I like the rear seat organizers but with the rear molle probably more in the market for just the bags.

 

[OverlandGearGuy]

Come up with a solution for bug screens / vents on the frameless windows and you can have my money.

As along as the Door frames are Metal I can do the Window Screens my screens are Magnetic


https://overlandgearguy.com/products/sprinter-van-front-driver-passenger-window-mesh-bug-screen

Sponsored