Help with Swapping fog lights

[Braptorx]

Hi, I'm swapping the factory fog lights for the Morimoto big banger kit, they have sent me a triple wiring harness, 6 connectors in total, with one upfitter connection, this also has the relays built into it, so all on or off, no individual control, as I have a mix of yellow and white, I would like some sort of selection, also thinking what do I do with the factory fog light switch? Do I leave this unconnected? What I would like is a harness with 3 upftitter terminations and 6 connectors, and the relays built in, now this might not exist, but I have always used relays in the past on the F150 raptor then I'm not tied to which up fitters to use. I'm not going to install this myself, but I would prefer to deliver the installer a finished harness, rather than rely on them here to "make it". any pointers greatly appreciated. Thanks

Sponsored

 

[4x4TruckLEDs.com]

The pigtails you just ordered from us will do that

CrystaLux DT 2-Pin to MX150 Pigtail, Pair (2021+ Ford F150 & Bronco Raptor Fogs)
https://www.4x4truckleds.com/crysta...gtail-pair-2021-ford-f150-bronco-raptor-fogs/

We also make them for other lights for those curious:

CrystaLux WP 2-Pin to MX150 Pigtail, Pair (2021+ Ford F150 & Bronco Raptor Fogs)
https://www.4x4truckleds.com/crysta...gtail-pair-2021-ford-f150-bronco-raptor-fogs/

And even a DT 4-pin
CrystaLux DT 4-Pin to MX150 Pigtail, Pair (2021+ Ford F150 & Bronco Raptor Fogs)
https://www.4x4truckleds.com/crysta...gtail-pair-2021-ford-f150-bronco-raptor-fogs/

So you'd want 2 pairs (1 pair for factory fog switch, the other pair would go to Aux 1, which is already in the fog opening). Then for your 3rd pair, you'd use this harness (it says a-pillar but works in the fogs also)

CrystaLux A-Pillar Wiring Harness, 2x DT 2-Pin Connectors (Diode Dynamics, Rigid Industries, Morimoto)
https://www.4x4truckleds.com/crysta...ors-diode-dynamics-rigid-industries-morimoto/

 

[Braptorx]

Thank you Adam for your assistance. You went above and beyond to sort this for me. Will post back once I have got it all sorted. One thing I didn't check was the amperage on the factory fog light. With the morimoto pulling at 3.2 (I think) do you think it will be OK. Not sure what the oem ones are?

 

[4x4TruckLEDs.com]

Thank you Adam for your assistance. You went above and beyond to sort this for me. Will post back once I have got it all sorted. One thing I didn't check was the amperage on the factory fog light. With the morimoto pulling at 3.2 (I think) do you think it will be OK. Not sure what the oem ones are?

It should be fine.

Sponsored