front led light install wiring help

[NOT OJ]

I installed the RC 20" light bar and the harness has a relay, inline fuse holder and a switch on it. I have the aux switches on my Bronco so can I just eliminate that stuff and just use the red and black wire coming directly from the light bar?

Sponsored

 

[j_marinelli]

Depending on the amp rating (which it should be fine" you can connect red to one of the switch wires and the black to a ground point in the engine bay. I have seen some leave the inline fuse in place for added protection.

 

[Copperhorse73]

Yep snip it all off, run power to an aux switch and ground anywhere. Check the amp rating of the light bar. If it’s less than 10 u can use any of the 6 switches. Here is a useful diagram

 

[NOT OJ]

installed and working! Thanks!

Sponsored