Bilstein B6100

[Doubleajaybrock]

Who here has these on their Bronco? If you leave the c-clip on the lowest setting (stock SAS height), did it still need a leveling kit or was that addressed by Bilstein?

pix will be awesome!

Sponsored

 

[Jms1]

Bilstein 6100, rear clip is set at the lowest groove, Front is set on the fourth groove from the bottom. On flat ground it has a one half inch rake, taller in the rear.

 

[Doubleajaybrock]

Do you have to disassemble the coil over every time to adjust the c-clip then?

Bilstein 6100, rear clip is set at the lowest groove, Front is set on the fourth groove from the bottom. On flat ground it has a one half inch rake, taller in the rear.

 

[23CarbonizedBadSas]

Who here has these on their Bronco? If you leave the c-clip on the lowest setting (stock SAS height), did it still need a leveling kit or was that addressed by Bilstein?

pix will be awesome!

Bilstein 6112s front and back at highest setting.

 

[Jms1]

Do you have to disassemble the coil over every time to adjust the c-clip then?

For the front assembly you will need to remove from the vehicle and compress the spring to change the c-clip position. On the rear I was able to use a spring compressor and make a c-clip adjustment without removal. I was very surprised i ended with the rear assembly c-clip set at the bottom groove.

 

[Doubleajaybrock]

Got them today

 

[Glenjafett]

Bilstein 6112s front and back at highest setting.

Are those 37 KM3s? Are you running a wheel spacer? Any issues?

Thanks!

 

[23CarbonizedBadSas]

Are those 37 KM3s? Are you running a wheel spacer? Any issues?

Thanks!

Yes, 37 KM3s, with 1/4 inch Bora Spacer, and JKS Tire clearance kit. No rub or any issues whatsoever.

Sponsored