Amp installation help

[BDavis81]

I recently bought an amp and Plug n Play kit from the forums, but am missing the installation instructions. It is a Musway six100 6 channel and the wiring harness is for front kicks, rear pods and sub. Included pic of wiring harness. Would anyone have the installation instructions to this or at least give me a heads up on where the free wires (speaker leads) connect? Thanks

Sponsored

 

[RagnarKon]

The "not-so-standard" standard color coding for car audio:

• White: Front-left
• Grey: Front-right
• Green: Rear-left
• Purple: Rear-right

Not sure if that harness follows the standard color coding or not, but you should be able to figure it out which speaker is which wire pair color with a fun game of guess-and-check.

 

[Shadowsquatch]

Did you look here?
https://www.muswayusa.com/downloads/Musway-SIX100-Manual.pdf

 

[BDavis81]

Well, the speaker wires are actually labeled:
Front left/right
Pod left/right

My issue was, because this is a Plug N Play kit, I assumed I wouldn't have to run a new set of speaker wires to these speakers or split into factory wires.

As I'm typing that out, I'm wondering if these are the wires that connect directly to the amp I'm installing. That would make more sense


Now that that is figured out, the four remaining plugs I assume probably go to the factory B&O amp and the ACM

 

[RagnarKon]

Lower resolution pic so some of them are hard to tell, but this should at least get you started...

 

[BDavis81]

Thanks man, this is helpful

Sponsored