- Thread starter
- #1
Hello everyone, been working on my new bronco and loving it, recently added a kicker sub and the ford fusion amp in my bronco, just wanted to share a few tips:
when installing the sub don’t put the foam retention ring back on, it’s not necessary and I had vibration issues personally.
extend the sub wires. The fake sun delete wires are a bit short I extended them and don’t regret it. This was my first time using forscan and while I watched a lot of videos it’s not hard to use, biggest thing I can suggest is saving a factory back up first. So if you make mistakes you can easily go back.
when installing the sub don’t put the foam retention ring back on, it’s not necessary and I had vibration issues personally.
extend the sub wires. The fake sun delete wires are a bit short I extended them and don’t regret it. This was my first time using forscan and while I watched a lot of videos it’s not hard to use, biggest thing I can suggest is saving a factory back up first. So if you make mistakes you can easily go back.
Sponsored
