Trunk bracket - M2DZ-7829452-B (part # includes 2 brackets and alignment templates)
Trunk bracket bolts - W707288-S442 (sold individually, need 10 bolts)
Right C-pillar bracket - M2DZ-78255A35-BA
Left C-pillar bracket - M2DZ-78255A34-BA
Right roll bar bracket - M2DZ-78515A52-B
Left roll bar...
Part M2DZ-7829452-B comes with the alignment tool, that's the one I ordered. I just realized I listed part M2DZ-7829452-A in my first comment, I must have pulled that from an old spreadsheet I had. I'm not sure if -A comes with the template, but -B did when I ordered it.
I am not aware of any fastback soft top that folds all the way back. The closest you might get is the Bestop Etop (link below), which folds all the way back, and has a slight rake to the rear window. Not sure I'd call it a fastback though. It operates electronically, which makes it pricier and...
If you buy the bracket as a standalone part (M2DZ-7829452-A), it comes with a plastic alignment template that makes installation a breeze. I'm not sure if you can buy the template by itself. I think I still have it up in my attic, so I can check to see if it has a part number, but I can't get up...
FYI, I believe the original bronco bolt is not a torx T27, but rather a torx plus TP27. You can get a torx wrench to work on the bolt, but it's not a good idea (prone to stripping). The TP27 wrench included with the bronco won't fit a T27 bolt.
From the manual:
"Note: Recirculated air may turn off automatically, or prevent you from switching on in all air flow modes except MAX A/C to reduce the risk of fogging. Recirculation may also turn on and off automatically in various air distribution control combinations to improve heating or...
0.2kWh is 200Wh, so that fridge uses 200Wh of power in a 24 hour period. Since the power bank has a capacity of 520Wh, you should be able to last roughly 2-1/2 days on a single charge. (520/200 = 2.6)
Sorry about that, I was writing from memory from when I did it last summer and must have misremembered. I edited my comment for future visitors to this post.
Yes, I'm pretty sure that ordering the $29 part from the attached link will get you 2 brackets. It's been a bit since I bought it, but that's what I remember anyways.
The bracket part is M2DZ-7829452-B. Brackets for both sides should be included.
The same bolts are used to connect the bracket to the truck, as well as connect the soft top to the bracket. You need 10 total (5 per side). 2 to connect the bracket, 3 to connect the soft top. The part number for...
Here's my setup with a tailgate molle panel & bags. The slipstream top slots into the 1 inch slip between the top flatish lip and the top of the tailgate. Basically, as long as your accessory doesn't stick up above the red dashed line shown on my photo, you should be fine.
Someone can correct me if I'm wrong, but the purpose of 5 tire rotation is to save tire life (each tire gets 25% less wear) and to prevent dry rot (where the spare rots out due to age, despite being unused).
The reason a Bronco has a full size spare is the large tire size, and the necessity of...
Not sure how much you've dug into it, but here are the soft top conversion highlights.
There are 2 main soft tops, the Ford factory one, and the Bestop Trektop. The Bestop is sold as a licensed Ford Accessory.
The Bestop is generally considered to look nicer (tauter fabric, no wavy back...