Search results

Just wrapped up my Dana 60 rear, Ultimate Dana 44 front, and Fox 3.0 upgrade and finally got to really test it at UBB running John’s Trail, Milts, Plan B, and Sliplock — and honestly, the rig performed flawlessly. The Dana 60 took a little extra work. It doesn’t come with all the factory brake...

Hmmm, Dana 60, dana 44 ultimate, fox 3.0 race coils :) -- need bump stops still, and maybe time for fenders lol

Id start with a base, since everything that made my bronco a badlands has been removed lol

:)

Interesting, yea its touching the boot pretty bad not sure whats going on

@!er Hey, did you have an issue with the Driver side CV boot running the Sway bar disconnect? Just installed the Ultimate front diff, and the sway bar is hard digging into the boot, only on the driver side.

Leaving it in looked through the center looks clean and intact

Don’t judge my welding I’m a noob 😅 but it’s out!

lol it’ll get done 🤣 this thing called work keeps getting in the way, I swear every time I ask it to go away it comes back every week

How it looked off the trail

We did a lot since it did rain so a little more spinning on rocks then I normally do lol and a couple bounces tha I was like 😬

Don’t broke somewhere between double Sammy and the chute, I maybe a mile from the water tanks in sand hollow and herd a clunk after stopping and going, sound similar to when I busted my upper control arm. So I pulled into the staging area wiggles the control arm and it was fine so I slide under...

Rep got some tube cut out may give it a go after dinner 😅

I got a tube from the scrap pile going to attempt to weld it to the broken axle and pray lol maybe get to it tonight

I thought about that yea the driver side has maybe 2 inches inside still it broke where the spline starts

New axles are sitting here waiting lol

Haha yea that was started this whole project

How da FQ do i get this axle out, lol broke the driver side inside the carrier which started this whole dissasmbling process , poped the tube from the passnager side out, and the axle in the tube didnt go with it like all the videos show. Any suggestions would help M210 4.70 gears

wait so does this like use your factory mirror to mount to? I thought it would replace the entire thing..