Search results

Can you resend me an email, i must have missed it. Just to clarify the issue here is the subwoofer cutting off right? If this is being powered by a separate amp It sounds like the issue isnt with the mObridge amp.

You need to use mObridge DSP not mObridge updater and it should all work

Audio systems start with the input. Personally I wouldn't be using Pac... It's the difference between a Mercedes and a Kia

This is going to depend massively on personal taste and speakers. What have you got installed?

They were always amplified however it was by the front ACM @20w RMS ish. Now they are driven off the back, they now would probably be running between 30-40w RMS at absolute best. We are yet to measure this though.

The C2s are only rated to 25w RMS so you'll definitely need to be careful! We push out 70. Also make sure that you have a high pass filter set at atleast 350hz on those dash speakers or you'll definitely blow them

**2025 Bronco updated B&O** Ok so we have been able to dissect this system and ill outline the differences between it and the old system. There is indeed a new amplifier, now all new Fords received an amplifier update in the 25 model year. This updated changed the A2B (audio bus)...

Sine sweeps and pink noise are both acceptable ways to RTA tune a car DSP. The main advantage is that sine sweeps will also give you phase measurements. However our DSP currently does not have the ability to correct for phase. That being said there are many cars that have won car audio...

That 4 pin connector that plugs into our amp is CAN from the factory connector. Not possible to wire internally Flick dipswitch 3 up

Which ones are you running in the dash? Any modification needed?

Kicker compr 8 inch!

Did you remove the factory sub amp?

I like the Hertz CX100s across the dash and then the MP165 in the kicks. The morels tempo ultras sound better but dont fit in the dash that well. The Audiofrog range is also another great option and they do fit!

This sounds like CAN is missing. Double check the CAN connection. Flat 4 pin cable that plugs into our unit. Pm me some photos

Are you looking for a DIY solution?

ive re-read it and youre right, maybe the title should have been. "Complicating and clarifying audio systems in the bronco" :LOL: I think the main take home point is, if you have a B&O system do it once and do it properly!

Hi Guys, I get a bajillion questions all around a similar topic so I though it would be easier for everyone if i dump my knowledge into one place. There are 3 audio systems in the bronco: Base: In this system the Heaudnit(ACM, Audio control module) drives all speakers directly, woofers and...

Send me a direct message and ill get it over to you

Great write up! For those on the fence about blocking the sub port I can't street enough how important it is. It makes a huge difference!

Just wait until you hear the morels if you think those Hertz sound amazing. It will ruin any other Stereo! Make sure you wipe the Hertz tune out