Search results

Nothing some spray paint can't take care of. The inlet mesh with the logo can come off and modified.

You cut a hole in the top of the stock air box, and it seals on the top, but there is nothing to block the stock inlet from letting in dust, water or anything else.

Installed an Airaid snorkel

The ditch light can go on the inside accessory mount (there are two per side) It just cant really face outward because the snorkel is there so I found there was no point. The antenna could have been left in place but day one when I bought the bronco, I installed the delete for a cleaner look...

Well I took the plunge and purchased the Airaid snorkel for the Ford Bronco. I had my ten minutes of fame when I was stuck in the middle of a mud hole and my motor stalled because of water intake. Everyone jumped on the picture/video claiming alternator but the alternator was fine and still is...

I have a friend who always pushes his stock big bend with no lockers, and he does really really well. I always doubt that his Big Bend will make it, but he has so far proven me wrong every time I attached a youtube video from a trip we did. It should start at when he took on the trail.

It was nice seeing the bronco raptor in person! I wanted to do the roller coaster but each time I went by the obstacle course, it was jam packed full of people.

Haha you certainly are not the only one 😝 Sometimes it feels like we don't belong in the off-road/overland community but it is good to represent. It is amazing how diverse the people are in the off-road/overland community. You have a great build so far and I am looking forward to seeing how it...

I know any vehicle can overheat but I was under the impression that modern vehicles would be able to limp home and shut off cylinders to act as an air pump to keep the engine cool for a bit with obviously reduced power. I know my father's 2004 F150 5.4 v8 has this because I read it in the...

A bit but I am not going to wheel it as hard as Broncbuster. I feel that the tie-rods are weaker than the steering rack so this is to help in that application. I do like the Broncbuster steering upgrade which I might eventually look into but it is definitely costly.

I am going to install these bad boys next week (ICON Tie-rods). Got them more for peace of mind but they are definitely beefy!

It was a lot of fun for sure! A bit crowded with a 45min wait on Blue Rhino. I was worried about you giving it too much gas on that one sand area. You got your wheels in the area, but I was worried about you going into the trees, so it worked out haha. I hope to camp with y'all next time! It was...

If you are only going to travel with the trailer and leave it at a camp site while you explore the trails in the Bronco. I am looking at getting this Coleman Lantern LT 17B. 2986lbs dry weight. Just watch how you load it and the bronco. I am sure you can keep it under 3500lbs or right at the...

I saw Jaggernaut had it, but I think it is a pre-order. Either way, I ordered it. Hopefully 4WP or a shop can install it because I do not trust myself to cut into the fender.

0 offset with sas flares

No lift on the bronco

They are the factory sas Goodyear tires with icons at 0 offset. The outer edge is higher than my sas fenders were.

They are wider than sas as well. That I know. My icon wheel and tire setup use to have a little poke on the sas fenders and these cover them.