Search results

I have installed them on the hoss 2.0 Badlands. Ran them for a week, removed them and put on Bilstein 6100's. The shock body was to long in my opinion. With the clip on the lowest Hoss 2.0 position it was an additional 2" above stock Badlands height. Than was not the worst of it, at that height...

This is still available.

PM sent

These were purchased for informational purposes. They were ran with my OEM Bilstein shocks for a month before switching to the next setup for testing. $200.00 Shipping is probably not feasible.

These were removed at 500 miles. I would like to not ship them. $125.00

New in box, not used. I sit at SAS level height and this is not necessary. $70.00 shipped

Yes, I agree. What I am referring to is the second photo in this post, it seems that the cv angle is extreme. I have no judgement as to that, was curious as to what the extended length of the front shock is. It would good information for a perspective buyer to know that.

I am curious to know what the length of the Falcon front Coilover shock is. I know length has been discussed and AccuTune adds a spacer to limit full droop on the King shocks due to cv angle. I know there was a chart somewhere on the site with different manufactures and the shock measurement...

The Icon's I mentioned above are terrible. They have been removed, back to stock. I have Bilstein's like you have on order. I am going to copy what you did. Thanks for posting your pictures.

I did take pictures side by side and the ICON shock looks to be well made and is impressive in comparison to the factory shock. I really wanted no more than 1" of lift in the rear (based on SAS height) being I want to stick with a 35" tire. Personal preference on height for sure. I chose the...

How did you get to customer service, I wait on hold for a extended time then it pushes you to voicemail. When I was able to finally get a person they were very polite but had no real knowledge of the product in question. I will try again, maybe I may be able to get a different individual. Thanks

I just installed a set of these shocks on a four door Badlands and have since removed them. They are advertised as zero lift if desired by clip placement. I can tell you that is not the case. I had 1.5" of rear lift in the stock Hoss 2 location. If i moved the clip to the stock Hoss 1 location...

Have you had much luck with ICON customer service? I had a issue with a set of there shocks last week. Their customer service was very disappointing. I hope you have better luck. You have a top of the line setup.

Does anyone happen to know what the SOD CMC module is and what it does? I believe it stands for side object detection control module. Mine has a DTC code P160A:00-2F, everything still works on the vehicle. Thanks

I have a set in the garage, we will see how they work.

What brand tailgate (tire)reinforcement is that? It looks clean.

Thank You Sir

So just to clarify these (MB3Z-18A099-E) will work with or are a replacement for the Badlands Bilstein shock Cap and I would need four of them. Two for the front and two for the rear, plus the following list you provided below. This would allow me to not disassemble my existing shock and...

Great, thank you Sir! The Bilsteins look great, there is not a spec of dirt anywhere on that Bronco. CV angles look really good as well, nice setup. Thank you for the information.

I am going to give these a try. Basically the same thing you are doing. I was just thinking about building the shocks before removing my existing ones. I would build two at a time prior to removing a set. So I would need two of the MB3Z-18A099-E and nuts. Additionally I would probably need the...