Search results

Thanks, I didn't know that. I'll check it out. I have the Mabett console organizer and never looked in the bottom of the console.

What is the 'emergency key fob access'? I don't know what that is and where it is?

A little off the subject but mine has a wide angle mirror in the upper right corner on PS and upper left on DS. Oddly enough the wide angle mirror is shaped roughly the same as the mirror only rotated 90 degrees. 2022 Black Diamond with just the standard trim package. I'm assuming that the...

What are the LOD tie in brackets? I'm using a Roadmaster Nighthawk with the 035-1 brackets but am using 'D' ring tow hooks in the lower opening of the MOD bumper tow 'hooks' and looping the breakaway cables then hooking on themselves. It works but isn't very clean. My RV has air brakes so I...

I built a plate that sits on the fusebox. It has one thumbscrew attaching it to the brace under the fender (had to install an M6 rivnut in the existing hole). I installed the Demco Air Force One and have a Brake Buddy Battery Charger that keeps the Bronco battery up from the RV 7 pin power...

I just finished the install and did my first test of the Air Force One braking system in my 2.3l 7 spd black diamond. It went into neutral tow mode just fine but after towing for a while when I was disconnecting and taking it out of neutral tow, I set the ebrake and I didn't get the sequence...

Panda Motorworks makes a really nice wiring harness that separates the lights so you use three switches to control three right and left 'pairs' of lights. I have the Diode Dynamics lights which have a Deutsch DT 4, pin connector. The ($49) Panda harness CrystaLux Triple Fog Light Wiring...

Thanks, my Black Diamond doesn't so the kit is 58996. Not all sales advertisements for the harnesses show with or w/o LED tail lights.

Do you have the LED tail lights? I know that there are two Curt kits, one for Bronco with LED tail lights and one for the Bronco without.

I went by the standard bolt torque specs for the rock rail mounts and was 2x higher than Ford recommends in the equipment installation manual. Fortunately I didn't do any damage. I found the Ford Equipment Installation Guide posted on one of these forums which has some of the torque values but...

I bult a plate for the RV to TOAD 6 pin connector and breakaway switch if that is the connector mount you are talking about. I have the Modular Bumper but don't have the ACC so I'm mounting it right in front of the (empty) box for the ACC radar. I've actually removed the box to get clearance...

I'm about to tackle the TOAD Light wiring as well. I'm hoping that the tail lights don't have to be removed to install the Curt Bronco TOAD lighting harness. I have the Trail Armor black plastic corner protectors that, if I have to take the tail light out, will have to be removed as well and...

There are lots of nice systems out there but I've used a TST 507 Tire Pressure (and Temperature) monitoring system for the last 5 years. As you can imagine, the temperature measurement is very slow to respond since it is on the end of the valve stem and I question its accuracy because of that...

If anyone is interested in a Powder Coat Color, the Prismatic Powders 'Black Diamond' (UTS-1527) BLACK DIAMOND | UTS-1527 | Prismatic Powders is the powder match for the Modular Bumper.

Well, I just learned something. Happened across this article in a Haynes manual. The picture shows a sensor with the frequency stamped right on it. It also says that the antennas are close to each wheel. I'm assuming by that that the range is really limited which makes sense otherwise you...

I have the same towbar and the same adaptors for my Modular Bumper. Clean system. Roadmaster makes a setup that removes the Modular Bumper tow hoods and replaces them with their twist and lock adaptors (which is what I have on my Honda CR-V). Seems kind of foolish to replace the tow hooks...

I think that I can read tire pressures from my phone via FordPass real time since the Bronco uses cell phone 4G/5G to communicate. It would be nice if one of the TPMS system manufacturers could come up with something. There are aftermarket replacement tire pressure sensors so someone has to...

May be on another thread (I didn't find anything in my brief search) but in the past I've used a tire pressure monitoring system for my RV and TOAD. I'm wondering if the FordPass can be used for real-time monitoring of the Bronco tire pressure while being flat towed. Or better yet if a Tire...

I purchased the adaptors as well and they do fit. I'm getting ready to purchase the Demco Air Force One brake controller (see my post in this thread).

I'm getting ready to purchase and install the Demco Air Force One (my RV has air brakes). I have the 2.3L so it should work fine. I'm fabricating a plate in front of the position for the ACC radar (I don't have ACC) to mount the 6 pin connector, air line connector and breakaway switch. I'm...