Search results

Yes, that's what's creaking.

You're probably right. At this point I am just thrilled that it's fixed, and I don't want to change anything. I may have gotten good results if I had just smeared some more of the brown grease that was covering it onto the plastic shaft. Since I can replace the whole spring assembly for $15...

I may have found a solution to the creaky clutch pedal issue. I've at least found the source (on my Bronco). TLDR My fix was to remove the clutch spring and separate the 2 halves. Then clean the existing grease off of the plastic parts and grease it with red wheel bearing grease. This grease...

The 2 door skid plate kit is available from Ford Parts. https://parts.ford.com/shop/en/us/bronco-2dr-2021-2025-steel-full-body-bash-plate-for-vehicles-with-modular-front-bumper-p-mb3z5d032d?pdp=y

Bump

I am giving away Underground Graphics 3 Bar High Red stripes. These are for a 2 Door Bronco. I ordered 3 stripe, but wanted 5 stripe. First 2 door owner to claim them gets them. Pay me for shipping if you feel like it. Just post a picture here after you put them on...

I really like that stripe. Where did you get it? Did you install it yourself? I also have a Cactus Gray 2dr BB.

I have set off the panic (by accident) at least 5 times since I got this Bronco in June. I've never had that problem with other Fords. (Keys were always in my pocket when it happened) I wasn't aware that it could be disabled in Forscan. Now I have a second reason (in addition to double-honk)...

I also experimented with this remote. If I hold the button while inserting the battery on this, it works. However, the negative contact for the battery is just a large pad on the circuit board, and I don't have confidence in being able to solder to it without causing problems. Especially...

I have a LiftMaster garage door opener. I got the whole thing wired up, but it doesn't work of the button on the opener is held down all the time. The opener that I used is 893MAX. It works fine if I leave the button un-pushed, turn on the Aux switch and push the button (so, it's getting the 3...

I am looking for feedback from people who have a ceiling mounted hard top lift. I have a 9ft ceiling in my garage and plan to install a roof lift. I plan to remove the roof for most of the summer so I need to store the roof elevated to make room for the Bronco in the garage. For those who have...

Don't forget about frontal area of the trailer. A large frontal area requires significantly more power (and therefore cooling capacity) to pull down the road at higher speeds. Unfortunately, the only frontal area specs I could find were a bit confusing (it lists 20 sq ft for w/o trailer pkg...

Check for loose battery cables. My son had a very similar problem on his Ranger. The battery terminal was just sitting on the terminal (not tightened). He had taken it to a dealer for body work and they had neglected to tighten it when they put it back together. I think the bad connection was...

Thanks for all of the responses. This is very helpful.

I'm looking for feedback from owners with the safe deposit box. Is it worth it? Do you like it? Any down sides? Thanks

I'm with you there. Both of my kids know how, and in fact took their driver's skill test in a car/truck with a stick. Now to teach my grandkids in a few years. It was already a novelty when my lids learned back in 2002 and 2004. Thanks for the info about your daughter. That's very helpful...

That's a good suggestion.

Thanks for the response. I changed the thread title to avoid confusion. It's funny that you mention the Mustang manual trans because that's what I have now. She loves the car but doesn't like to drive it because she can't see over the hood.

I have a 2024 Big Bend M/T on order. I'm looking for feedback from people with shorter inseam (26" or so) with driving the M/T Bronco. I've noticed in some reviews of the Bronco with M/T that they mention the low clutch engagement point. My wife would be driving this occasionally and her...

Hello all. I recently ordered a 2024 Big Bend M/T, but I am considering upgrading to a Black Diamond if I end up "downgrading" to A/T ;). (I really want the Black Diamond, but you can't order the Mid option pkg on Black Diamond without adding A/T). I'm a retired Ford engineer (most of my time...