Search results

FORscan for sure works. Just need to make sure you unplug both resistors and change the correct setting. There's 2 settings in BdyCM Module Config. One says Rear Bulb and the other says Rear LED. If you had the base lamps, you need to change the one that says Rear Bulb Turn Outage to Disabled.

Yes! The setting is in BdyCM (Plain Text - Not AsBuilt) and is labeled "Rear Bulb Turn Outage"

DRL is not LIN controlled. Pin 8 turns on with IGN and times out after a few min when the truck is turned off, though.

PM'ing you to get this sorted!

Hey Chris, Check the 2-Pin plug at the resistor for corrosion. If found, clean and add di-electric grease. That should resolve the issue. If not, shoot me a PM and I will get you set up with a new resistor there.

Hey Mike, If you followed the instructions and cut the fin on the bottom strip, it should stay in with no issues. However, we have found that if too much material is cut from the fin, it can fall out easily. In that case, you can use a clear drying glue such as Cyanoacrylate Glue in small...

Our ETA for those are on or before 3/31.

Shoot me a PM with your order details & I'll get you sorted!

Can you PM me some detailed pictures so I can try to understand where the obstruction may be?

No plans for that at this time!

The amber on red is 🔥

If you understand LIN communication & can program an MCU to read the linbus command for the high-beams to turn on, sure you can do this. Otherwise, this is not possible.

Indeed they are!

Not doable because of the Signature Lamps having a separate amber LED for turn signal. This is powered by a separate wire in the plug that yours won't have. Might be able to do some fiddling in FORscan to make the Red Brake / Running Lamp function as a signal also, but haven't tried it to know...

There's a rubber gasket on the mirror arm that can snag the bottom around where the cover meets the arm. If you fold the mirror assembly in & out a few times, you should be able to get this to settle with that gasket. You may need to also re-set that bottom corner after doing this to get it to...

We'll be looking at offering a ColorSHIFT version in the future!

This is legit one of my favorite things i've seen here.

Correct!

Yes, we're still working on these. Here's a shot from preliminary testing showing the dual function reverse lamp.

The issue is that there are only constant powered wires in that harness & no grounds alternate with the door triggers (In the case they would be negative triggers). I am going to comb through FORscan to see if there are any options to enable the option for the OEM puddle. If so, that may be the...