Search results

Can anyone list their height from ground to middle of fender flares (front and rear)? Also please list Sasquatch or not and also the lift of you have one.

When you get a chance can you measure from the ground to the middle of your front and also rear fenders? Just curious the height your sitting at now.

Has anyone adjusted their headlights after lift/level? I just did mine. Clockwise will lower and counter clockwise will raise. I’m not sure how accurate my adjustment was but lowered it about 2”.

$1200

I’ve ordered a set of 30mm (1.18”) wheel spacers from Motorsports-tech (Bora) and may go a different route with my build. I ordered them over two weeks ago so hopefully I get them delivered soon. I paid $317 for them. Asking $300 shipped or 275 local pickup

Anyone measure before and after? I don’t believe I’m getting the 2.25” height in the front. To me it looks like 1.75” in front??

Nice! Is that with alignment too?

This is the look I’m wanting. Any trimming or rubbing? Do you have anymore photos to show the stance and poke?

It was $700 for labor and alignment. I had another shop quote me a similar price as well.

A garage did it.

Cool. Did you get the full 2.25”? I did a quick measurement and I don’t believe I did but it was on a surface that wasn’t 100% flat.

Visually it looks level but I’m going to do some after measurements later today to see how much height I’ve gained

RPG

😂 I knew someone was going to wonder that. You correct though.

Just had these installed and think it came out great. Will add 37s in future but the 35s do not look small at all imo. Ride is just a tad bit stiffer but nothing drastic.

Thanks

Nice! What’s your offset?

I like it! What offset you running?

Ok great. My wheel spacers will be 30mm so that should be perfect then. Thank you

I’m looking to get a wider stance than the +30mm factory offset. I’m going to order Bora wheel spacers. Lift is a 2” perch collar lift. I’ve read to go with 0mm offset. I do want a bit more “poke”. Would you like a slight negative offset work as well such as -5mm to -10mm?