Search results

Only dreaming.

Yeah I’m actually considering lowering my lift on my Bilstein 6112s. Instead of 2 inches going down to 1 inch over Sasquatch. I had a few times where I got tippy in Moab and a lower center gravity would have helped. However I’m not sure I wanna give up clearance on my belly so may go 1.5 inches...

I was at 2 Walmarts and noticed the large 5 quart jugs of 5w 30 oil are flying off the shelfs! I had to buy the smaller 1 quart jugs because the large jugs were sold out and ended up costing me a bit more for my oil change. Anyone experiencing this in their area? I heard on the news it’s...

If you’re doing serious rock crawling you want as low center of gravity as possible. That’s why all the expensive rock buggy’s are low but have portals and big tires to make up for the clearance. If you lift up high you will have higher chances of rollover and lose downtravel. I have to admit...

No front solid axle? Hard pass for the crawler folks.

I store my Bronco over the winter months. I simply change the oil before storing, hookup to battery tender, put sticky traps down under vehicle, make sure tank is full and tires are fully inflated. When I pull the Bronco out for Spring, I hold the brake pedal, gas, and then the start button to...

I noticed with the stiffer sidewalls I don’t lose as much ground clearance when I air down the Mickey’s vs the Good Years

Not the best photos but hope that helps.

I will have to take a picture of my tricky dicky tie rod repair kit. Honestly never used it and been through some tough trails in Moab, Colorado, and Wyoming.

Nice bronco. Whatcha running for on road air pressure? Im running 30psi seems to help for even wear and soften ride after chalk test. Offroad they work great, I usually run about 10-13psi offroad depending on how rocky the trail is. Last season, on a overnight camp trip on the trail we got hit...

I have the Borla Climber catback stype. Great sounding exhaust. My biggest concern on the 2 door is the muffler is supper close to the drive shaft and brake lines. Has not hit or anything and doesnt move. I emailed Borla and that was their overall design goal to maximize size but keep it within...

Bad timing. Just paid off my Ranger Raptor. Please offer another discount for July 4th holiday. 😂

I noticed that when my Bronco was new. I had to top it off once with the ford coolant. Since then I haven’t seen it drop at all. But I only have about 16k miles.

Howdy can you also do a post with the rest of your Baja build? Maybe break down what all your running to complete Baja.

Good afternoon hoping you could snap a few pics from what the storage looks like from the driver side looking back and how much gap between the front seats. Thanks!

Maybe I would wait. See if Ford does another special edition color or something.

Good find. Much better than dinking around with the stock jack.