Search results

Do...do those just bolt on? Or are they welded? FFS now I have to go look at my Bronco again

Ah, you probably need to watch some videos on synthetic line break tests. They don't simply fall to the ground, it's far more violent than that and probably faster too, but since they're so flexible they do tend to stay on the path they're being tensioned on, so they're at least more...

Really? Not even Big Bend, Escondido, or Wolf Caves?

Have you guys seriously never seen a winch in a box lol I mean, it's pretty awesome that OP made one himself, but the idea isn't exactly new.

Not in this case, at least, not with a handheld. By the time the fire was even noticed, it was too late. Automated extinguishers may have put it out while it was still small, or gotten it under control enough to where a handheld would have taken care of it, but that's all hypothetical.

The best octane boosters out there are lucky to raise a fuel like 87 octane up to 89 octane, and that's at their maximum mix ratio. Go beyond their max ratio and you will ironically start producing deposits inside the cylinder and spark plugs that will contribute to detonation and pre-ignition...

I don't think there's any one mod that I use or like more than the others, they all have their place and are the absolute best mod when I need them. But maybe the 200 shot of nitrous.

Good lord, you knows it's off when you can see it from that far away E-brake and a tree should square that right up :unsure: If you go too far, just bash it into something and try again LOL

If you're talking about molds, why not just try some babbit? It's soft enough that whatever runout the housing might have would likely be addressed when the outer surface gets scraped off on the housing during install. Plus it's super easy to cast, arguably easier than lead because it pours so...

Coolant won't autoignite until something outrageous like 750F, and that's tough to do considering the water component will rapidly quench whatever heat source is above that temperature. I've seen a not-so-intelligent amateur blacksmith using a bucket of coolant to quench his 1500F blades in...

Sounds like the frame horn supports are going to thicken more than the plot LOL

First time using that trail assist cruise control thing was like a trust fall exercise for me It just doesn't feel right to use it LOL

It's probably more of an inability to integrate rather than intentionally segregate. They'll come out with a patch eventually, maybe, who knows.

Spending the money is the easy part, wait until you get around to installing it lolololol

Sorry about your Bronco, OP. Sometimes vehicle fires happen and it's nobody's fault, don't pay too much attention to the wiring and lighting comments, it's extremely unlikely that a factory and/or fused circuit was a contributing cause. More likely a statistical failure of a component or...

4DTech makes a few modules for the Bronco https://www.4dtech.com/canopener-motion-unlock-360-camera-unlock/ I haven't done much research but I think Naviks might make a similar module too

Let me send you a shipping label to stick on that box I'll figure out the rest eventually LOL

It wouldn't be much use in a 2dr. I mean, you can take the rear seats out and probably fit the box in, but the panels that fold out for the bed wouldn't have enough length. I doubt there'd be enough length even if you pushed the front seats all the way forward, but...maybe? I've seen where a...

Keep begging Ford for a V8 and they're going to resurrect the 255 V8 in 2024 just for you guys.

Thought this was an April Fool's prank, then realized it was May and it couldn't be a prank, then realized that Ford releases things way later than scheduled and this probably was a prank, then noticed people actually downloaded it and figured it wasn't a prank, then got to looking at the bugs...