Search results

I have them and they work great! Easy to ratchet it down and also provides another option to tie-down gear. Their support is also great (I was an early user for these and they offered a metal anchor for straps that was too short for the Bronco - they took it off their site and reimbursed me...

SCCM module...

you likely need to go into the PDM (Passenger door Module) module and turn on the feature. Sounds like the Driver was done but passenger may have a character wrong. PDM 741-06-02 xxxx xxxx 01-- PDM 741-06-03 01xx xxxx xx-- check these two areas. 741-06-02 is close and...

Did you get this resolved?

If they fail then you likely need to reset the windows by holding the window switch up and once it hits the top count 3-5 seconds, the hold the switch down, when it goes all the way down again continue to hold the switch 3-5 seconds. This will reset the up and down limits for the window and for...

Thank you George - I placed an order for -CA about 3 weeks ago. Was told they would get inventory 12/31 but they were only expecting 6, and they didn't know how big the back-log is... Seeing how @Bee Bop placed one for an F150 but single fog I was hoping there would be a dual fog F150...

Does anyone know what the part numbers are for the dual fog light switch? I know that M2DZ-11654-CA is the Bronco Dual fog, but I don't mind swapping switches from current factory switch to the new switch, and the Bronco is on a national shortage.

The light doesn't come thru the front, just the sides. A patriotic look would look good.

@JcrOffroad if you wanted to add a wooden table that slid out to the right, would this be possible? Similar to how Goose Gears table works? Table extension Would love to have this ability for the times you need extra space or a cutting board. If the right side is open between the table and MOLLE...

Just seeing this, I'll add it to the spreadsheet, but where are the steps to enable this?

I used the center of the grill as my tie in point. Had the B R O go to the right and N C O go to the left. I but the wire length so that the ones closest to center were shorter so that I had very little excess. I then soldered the positives all together and same with negative. I bought 10' of...

I have a temp install - tied to fuse that is Aux powered. Still trying to locate what wire I can use which is tied to the DRL or driving lights. No luck around finding the right wire - but haven't run a tester to any wires. Hopefully someone has a wiring diagram I can use ☺️

We didn't have to drill to install for wiring, just to extract the original letters. The wiring passed thru the holes that the original letters used.

What wire did you tap into so that they work with the DRL's? When you tapped into it did you use a relay or just directly into the DRL wiring for power?

Any updates to the release?

So with this change, it looks like if you have 2x ss3's installed the middle light now is more exposed? (the old kit appeared to block about half of the bottom lights). The pictures on the site, is the first with the new bracket and the rest with the old?

Thanks @BronchoPeat See if they wouldn't mind just selling the brackets? I'm thinking it would be easy to fabricate a lift/hoist if you have the brackets.

How do these rear brackets attach? Wondering if they could be used to build a hoist to lift the hard top - you'd need 4 of them.

I should have posted here instead of the other forum - Mine arrived yesterday - looking forward to installing this weekend. Quick question - has anyone been able to tie the lighting into the running lights or driving (low or high) lights? I'm not looking to use a switch to control them and...

Mine arrived yesterday - looking forward to installing this weekend. Quick question - has anyone been able to tie the lighting into the running lights or driving (low or high) lights? I'm not looking to use a switch to control them and having LED factory lights know that its a bit more complex...