Search results

Anything yet for the B&O System? I installed the Key 500.1 to the existing sub speaker using the high-level input and a new sub speaker and now sounds amazing. Want to do the remaining four speakers with the key 200.4 but don't know the pinouts for the speakers. Was hoping there was a...

Looks great! Do you happen to have a picture of the subwoofer remote level mounting? Thanks!

Thank you. Yes. High-Level inputs. You do not need a converter. If you have any issues installing it, just let me know. I did use felt tape on all the clips... etc. Followed what the other guys were using.

Thanks to all the previous posts on the thread, I installed a Kicker Key 500.1 and dual voice 4-ohm sub. I ran the sub in parallel so I have a 2-ohm sub. I mounted the amp right next to the sub so all concealed now. I used double-sided foam tape and screwed the amp to the chassis. Sounds great...

Thank you!!!

There they are! Do YOu think these rattle and so you don't like them?

I was referring to the clip that goes into the metal body. The hole in the body is 9.3 mm. I need a clip that has an opening of 10.5 mm or so. I just ordered these so I will see how they fit. It is a an opening size of 11 mm. Thanks for the help...

I just measured the hole in the body and it is 9.30 mm. The factory clips are ~10.5 mm, so when it is compressed in, it stays in. I will try cutting the clips. Thanks!

I am I am referring to the hole dimeter. The clips I got have a larger diameter and are jammed in the hole. You destroy the clip getting it out (just the clip with no panel connected.) If the panel was attached, I would break the panel getting it out.

Thanks! Do you have a link to the clips you bought? I bought these and they are super tight into the body. https://www.amazon.com/gp/product/B07CJLB446/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1 If you have the link, that would be awesome!

Looks great! Did you use the clips you have shown? I bought some and once you put them in, you cannot take them out! How are did your clips work? Can you remove the panel after installation? Do you have a link to the clips you used? Thanks!

e.

I followed these instructions to remove the console. I also installed the auto start/stop disable so this video helps.

SWR stands for Standing Wave Ratio. How well the antenna has matched the radio. You ideally want a 1.5:1 ratio or lower. 1:1 is a perfect match.

Midland MXT275. I put all the links to the products used.

Here is an easy/clean install of a Midland GMRS radio and mic and phone holders. The SWR is 1:35. The ditch light does affect the SWR. Without the ditch light, it is 1:1. You have to play with the movement of the antenna to get the SWR down. The small midland is mounted inside the center console...

You are welcome. I used a large drill bit to start the hole and then use the dremel to finish it off

Plenty of room. This is what I used. https://www.amazon.com/gp/product/B01MY04R2N/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1