Search results

Just want the throw a few facts out there for your research. Old Man Emu is from Australia where lifts are illegal. This is the reason they rate them in weight instead of height gained. So what you are looking at there are three different height lifts at a given weight. Six of one, half...

To run a tool you need 90 psi and 5-ish CFM. The ARB will build to 100 PSI, but you need a tank to do that. And the flow rate of the single is not high enough. So to make it work for a short time you need the tank, and would be better off with the double.

I'll talk you into a double! How 'bout that? If you want to run air tools you'll need a tank, 1-2 gallon. As far as single or double, the double is just two singles wired and mounted as one unit. So double the CFM and redundancy. The up side you only have to wait half as long between air...

I have the same covers. If they are slipping then they are installed incorrectly.

Looks like a short bus OBX non-sas to me.

The OEM one is supposed to be replaced every time. Just sayin' $2.40 each https://www.amazon.com/gp/product/B09Z25LV5J/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&th=1 The trick is to keep the plug in the stream to limit flow. Twist the plug out partially, do not fully remove, and regulate...

I always thought it was done for people that did not know how to modify their vehicles, or those that would pay someone to do the work anyway, in that case why not have a way to finance the mods. They can't due to current laws in place. This is the main reason why Ford separated out the...

Seems like there should be some product you got place there for reinforcement. Thicker piece of material and attached with adhesive. I have a carhart cover on mine but that would not stop this issue. Ordering a replacement piece for use when selling sounds like the way to go.

They were putting in 7 speaker, bass in the rear has been deleted, that is a credit for going without.

Still remember him from the 5th Avenue commercials. https://en.wikipedia.org/wiki/Chrysler_Fifth_Avenue

Below is a diagram of the power circuit, not the switches in the cab. Is the "pod relay" you are referring to a relay you added to run the lights? If so, sounds like the added relay, when it shorted, took out the ford factory relay (that is operated by the in-cab switch). In other words I...

It is highly unlikely those LEDs are drawing that much power. However I'd use a relay. Also it may be handier to have them on their own switch.

So you don't have to remove the center bar and screw attached straps in the back. I installed the shade last weekend and re-installed the hardtop this weekend, took me a minute to figure out how to access all the latches, but it does work. The mesh top is not in the way at all and IMO...

The mesh top is made to stay in place under either weather top. You only have to mess with those screws when you install or remove the entire mesh top. With the other question, we may need more info. But from what I can gather your aluminum center support seems to be looser than it should...

Beginning of memorial day weekend. First time topless....

Use the info in post #5 and #6 and that would be cheapest way out of your situation. If I was you I'd mount a 7 pin connector and wire it with post #5 solution and then use this $10 adaptor. https://www.amazon.com/gp/product/B07SQJHPMY/ref=ppx_yo_dt_b_asin_title_o04_s00?ie=UTF8&psc=1...

The 10 speed trans is a different animal with a lot of quirks. I'm not sure but what you may be feeling is the down shifting, the trans tries to keep the engine in a certain RPM range. Over the last 7K miles I've gotten more used to the behavior but is still my least favorite part of the...

I have a stack of RTIC coolers that looks like a store display. Also have a larger portable fridge. If I have access to power the fridge is the first thing I grab; to convenient, less mess, less hassle, no soggy items, no additional trip to store for ice, able to keep food at exact temp...

I guess it comes down to personal acceptance, some people get used to the noise more than others. It is important to note there is a reason ford gives you two different bracket sets, one for hard top and one for soft top. So, when going aftermarket the brackets may not be suitable for the soft...