Please Share Ideas of Outfitting Your Bronco for Hunting and Fishing - Especially for extended Trips

[OEB0122]

Yes Sir. Iwans Kennels, PA. Are you a PP owner?

Very cool. I am . My first was from Iwan's - his A litter (Iwan's Artemis Citori, RIP). Now I have a High Power dog from her A litter.

Sponsored

 

[redone17]

The newest version of The Rod Rig is

 

[KABQ]

The newest version of The Rod Rig is

Which one?

 

[redone17]

Which one?

https://therodrig.com/

I believe it’s the only one they sell. But, I had their prototype version before this and the improvements are noteworthy. BuiltRight Industries acquired the company early on and they don’t cut corners. Great customer service too.

 

[Denis85]

While I can't comment on the rest of the overlanding gear, I used a molle panel and some universal molle clamps from Rough Country for the inside of the tailgate. Just measure the diameter of the rifle or shotgun and go with that. The only issue you may have is depending on the length of the rifle/shotgun, it may interfere with where the tailgate starts to bump out towards the latch hardware.

Rubber Molle Panel Clamp Kit | Universal | 1" - 2 1/4" | 2-Clamps | Rough Country

 

[KABQ]

https://therodrig.com/

I believe it’s the only one they sell. But, I had their prototype version before this and the improvements are noteworthy. BuiltRight Industries acquired the company early on and they don’t cut corners. Great customer service too.

I like that a lot, and it definitely looks easier to use than my setup, but damn! $$$

 

[redone17]

I like that a lot, and it definitely looks easier to use than my setup, but damn! $$$

It was $245 when I got it. Since 2024 Matt has replaced parts under warranty and then followed up and sent me V2 when it was ready. I got to keep V1 as well. It’s built to last and works flawlessly. I have 2 casting, 2 spinning and a fly rod (I keep the front 2 sections in the tube) at the ready at all times. No noise, no bouncing.

Sponsored