Search results

For those still following: TrailRax now has a solution for the painted hard tops, FYI.

Very cool. I am . My first was from Iwan's - his A litter (Iwan's Artemis Citori, RIP). Now I have a High Power dog from her A litter.

@BroncoHunting - Is that a PP? If so, from what kennel?

Ha ha - more confusion for the OP...but, if/when you choose painted hardtop, also make sure you measuring the mounting point on the specific Bronco you are looking at. If the slot is less than 1" deep....you lose some roof rack options (like TrailRax).

On the top slots, in the rear of the hard top (where the roof rack would clamp), slide in a simple ruler. (If you do not have a ruler, use a piece of cardboard, and mark the edge - then measure that.). If your depth is over 1" then the TrailRax can be mounted properly. If just over 0.5" then...

From what I have been told, it may vary by the provider Ford sourced it through...I do not know for certain. Unfortunately, I did not even know to measure mine until my TrailRax had arrived and I was prepping to install.

I am in the same boat with my gray painted hard top.....I too have the 0.5" depth rear slots. So, I wasn't sure how large the lower tabs were on the @Hooke Road® rack. When looking at a YouTube video, they almost looked small enough to fit....but trying to find a way to confirm. Our other...

@Hooke Road® - can you confirm (or deny) that your roof rack works with all versions of the 2025 painted hard top? I know there are other manufacturers whose mounting system does not work with some variations of the painted top due to Ford's use of several vendors and different depths of that...

Thank you! That is my primary concern with the Gobi....the lack of "flexibility" with mounting solutions. With my 2 previous adventure vehicles, I loved the modularity of the extruded aluminum channels, and being able to space them just about anywhere I went. I am looking into the...

Ends up, my sexy looking painted hardtop ended up being an early fault in my planned build. I really wanted, and purchased the @TrailRax - only to find out that I have the painted top that will not accept their mounting system.....so, now I am looking for my next option. I am not going to...

Thank you. I will look at your kit again, and try to figure out where I could then mount a manifold.

Question to those who may know and help. I want to put an ARB under my hood (25 Badlands SAS), but I am also considering putting airbags in the rear for towing. Can I plumb the airbags off the ARB manifold?