Show me your 3D printed accessories. 3D Prints for Bronco Enthusiasts.

[KillerPenz]

Only thing that might throw off the calculation would be supports if necessary (not sure if factored into your count or not).

I managed to lay out the parts that the only thing that needed any extra support during printing was the lower pocket. All the rest were able to be printed in place without any help

To be honest I just slapped it into Bambu Studio and sliced all plates. Normally I would mess around and flip objects if it's beneficial. So the 450g it returned seemed like a pretty good baseline.

In the past I looked into adding color to the name & logo, but that returned quite a bit of waste.

Sponsored