Mounting Solution for Bluetti Elite 100 V2 to Molle Shelf?

[eblivr72]

Has anyone found a good way to mount a power station to a Molle shelf, other than ratchet straps or bungee cords?

Sponsored

 

[HighVelocity]

zip ties

 

[eblivr72]

zip ties

Aside from the carrying handle, I don’t see any attachment points to zip tie it to. It’s sitting flat on the shelf.

 

[Mikerider]

Not mounted to a molle panel but I built a small bracket to hold my 600WH gooloo battery pack that runs my starlink and fridge. mounts to the roll bar and soft top mounting points

 

[abdiel.villalobos]

Has anyone found a good way to mount a power station to a Molle shelf, other than ratchet straps or bungee cords?

Well, I don’t have a Bluetti or an Yetti, or any of those expensive battery power stations, I got a Rough Country Battery Power station and it been doing a great job.

I was also looking for a mounting solution for it since I didn’t want it bouncing all over the back of the Bronco. I found on Mountain2Metal that they offered a mounting solution for the Yetti 500X, it was a little smaller than the RC power station I have but with a little “Frankenstein ingenuity “ I made it work!

hope this helps!

 

[abdiel.villalobos]

This might be a better representation of my setup.

 

[eblivr72]

This might be a better representation of my setup.

I like that. Might try to make something like that. Thanks

 

[retiredarmymp]

I made a Velcro strap that goes around the BLUETTI and the bottom/side of the shelf, and a block system to keep the BLUETTI from sliding around when off-roading.

Sponsored