Search results

Turns out the issue is the Capable bumper sensors. They connect on the end, versus on a 90 degree bend. I’m trying to source some 90 degree parking sensors and see if the work with the capable harness.

If it were only that easy! The instructions are for mounting the Rough Country winch. I’m about 1/2” away from the mounting holes, so gringo g a corner won’t be enough. Thank you though.

I’ve seen where people have mounted this configuration, but I’m running into an issue with the winch not being able to mount because it’s butted up against the locking plate behind the RC sensor relocation mount. What have you guys done to remedy this? Thanks in advance!

I’m sure it’s been done a bunch, but just curious if all the sensors will swap over without different sensor mounts??? Are they the same?

I like that. Might try to make something like that. Thanks

Aside from the carrying handle, I don’t see any attachment points to zip tie it to. It’s sitting flat on the shelf.

Has anyone found a good way to mount a power station to a Molle shelf, other than ratchet straps or bungee cords?

We have a fairly new 2025 Badlands with the 2.7. We’re pretty happy with it, but was recently given a 2026 Big Bend with the 2.3 as a loaner. We’re pretty surprised at how much more responsive the throttle is on this thing compared to our Badlands. The ride is better as well. I kind of...

See, I keep hearing horror stories of these nuts falling into the tailgate.

Before I screw up here, the captured nuts for the tailgate hinge…are they solid plates, one for the top two bolts and one for the bottom?

Installed MetalCloak rear diff, rear shock, and rear lower control arm skid plates. These things are solid! Easy installs and they look sweet.

My GOBI will

Display shows a red X on the roof, so I’m assuming the rack is the cause. Anyone experienced this? If so, what can I do to fix it?

GOBI was able to provide some advice and I got it together.

I’m installing the Stealth rack and have wasted way too much time and energy trying to get a support bracket on the drivers rear frame bracket to line up. I’m at the point of just enlarging the hole, as I’ve already ruined the powder coat. Anyone have any ideas?

Front right fender or door. Hard top and no rack. The only thing removed were the flares. They seem to be on correctly and solid.

I had PPF applied to the front and sides of our Bronco this past week. Now, when making right hand turns I’m getting an annoying squeak. Any ideas as to why this might be happening?

Not sure how the wires got crossed, but this picture better depicts the issue. These slots are the issue

Here’s what mine looks like.

From what I’m gathering, some of the painted tops were manufactured at different locations and were designed differently. Specifically the rear mounting points. TrailRax had me take measurements and pictures to send them. After reviewing everything I sent they said it wouldn’t work...