RTR End Caps? Anyone using them?

[psdtime]

I was wondering if anyone is using the RTR Tubular End Caps for the modular bumper and also has the lights in the bumper (fog light area). I like the way it looks and I think it would be a good addition to my IAG bullbar, but I'm concerned it might interfere with my 3x Squadrons that I have hanging below my bumper now. Thanks for any comments/opinions.

Sponsored

 

[glashaus]

I have them on my Badlands, I like the look, opens the front up a bit more than the stock mod bumper ends. I do not have fog lights though. It gives a look that is different than stock.

 

[psdtime]

I have them on my Badlands, I like the look, opens the front up a bit more than the stock mod bumper ends. I do not have fog lights though. It gives a look that is different than stock.

Thanks for the reply. I like the look too, but I really need to know it they interfere with the fog lights. I have the SPV Baja Design kit and it looks to me like the RTR ends actually have a bigger opening, but with my luck, I buy them and they don't work. Doesn't seem like a lot of people have them, which is surprising since they seem to enhance the look so much.

 

[glashaus]

Thanks for the reply. I like the look too, but I really need to know it they interfere with the fog lights. I have the SPV Baja Design kit and it looks to me like the RTR ends actually have a bigger opening, but with my luck, I buy them and they don't work. Doesn't seem like a lot of people have them, which is surprising since they seem to enhance the look so much.

Take a picture of your lights and the dimensions. Do they mount to the bottom of the bumper?

I think that the opening at the center of the RTR ends are wider than the stock Mod bumper ends but as you get to the outside end it may be narrower than the stock mod bumper ends. It may be a little difficult getting a lot of the fog lights that are designed for the mod bumper to work. I still have my mod bumper ends, I will take a look a t them later to compare

I don't think that you see them because they are a little pricy for what they are and just like you, people don't know if fog light kits work with them. Also not sure if a lot of people know about them. I saw them in a post about a year ago, shortly after I took delivery of my Bronco, and ordered a set. They really do look great.

 

[psdtime]

Take a picture of your lights and the dimensions. Do they mount to the bottom of the bumper?

I think that the opening at the center of the RTR ends are wider than the stock Mod bumper ends but as you get to the outside end it may be narrower than the stock mod bumper ends. It may be a little difficult getting a lot of the fog lights that are designed for the mod bumper to work. I still have my mod bumper ends, I will take a look a t them later to compare

I don't think that you see them because they are a little pricy for what they are and just like you, people don't know if fog light kits work with them. Also not sure if a lot of people know about them. I saw them in a post about a year ago, shortly after I took delivery of my Bronco, and ordered a set. They really do look great.

Thanks for the reply. It's definitely a tight fit with the stock bumper.

 

[glashaus]

Thanks for the reply. It's definitely a tight fit with the stock bumper.

actually it may work, the geometry is different, looks like the fog lights would mount in front of the lower bar, could be some spacing issues

 

[psdtime]

actually it may work, the geometry is different, looks like the fog lights would mount in front of the lower bar, could be some spacing issues

It might work, but it might also look odd from the side after looking at these pictures. Might see too much of the housing.

Sponsored