We used to stock Zroadz stuff but stopped promoting it. This was around COVID times when there were supply chain issues. We mainly sold their mounting brackets.
I cancelled my order and am going with the Baja Designs 6XL Linkable Bumper Light System. I was going with BD for the lights anyway (on the ZRoadz bar) and really like the low profile of the bumper attached system. The bar mounted lights tend to block airflow and I did not want to have that happen.
we sell that right here: https://www.4x4truckleds.com/baja-designs-xl-linkable-kit-w-6-xl-lights-for-2021-ford-bronco/
Hello, just to clarify, we manufacture all of our Steel Products in-house in Corona, Ca. as well as our other brands like T-Rex Grilles and US Rack. If you were looking at a kit, where you see lights and brackets, yes, we do list kits as “Made in USA”. This Is due to customs guidelines for importing. This is a common practice and is used across many markets specifically accessory brands like ours. If it states “Made in USA” under the LED only, it’s a mistake on the site. Let us know where you saw the issue.
@4x4TruckLEDs.com - this one may be for you.
I've been running the ZROADZ front bumper light bracket with a pair of KC SlimLites for over two years. No issues at all, no rust, it's very well made.
I purchased your roof lights with roofrack kit so thanks for the explanation. When I checked on the light pods as stand alones, however, they state Made in the USA. So this is not accurate.
Technically.. it says American made.. which IS legally different than labeling something as 'made in USA'I purchased your roof lights with roofrack kit so thanks for the explanation. When I checked on the light pods as stand alones, however, they state Made in the USA. So this is not accurate.
like the @ADV Fiberglass top 
Those are all default information links for all of our site pages. Products that we manufacture in-house will have it listed in a bullet point under the features.I purchased your roof lights with roofrack kit so thanks for the explanation. When I checked on the light pods as stand alones, however, they state Made in the USA. So this is not accurate.
Check out our kits here... YEAH some of them (like the Baja Designs one) cost money BUT you really can't beat the price. Buy Once/Cry OnceI purchased a Zroadz 30" single row light bar with mounts as sort of an experiment. I wanted to see what works for me and didn't want to spend a ton of money right off the bat.
It's was a Ford Bronco-specific kit but it doesn't fit. The depth of the light is such that the heat sink portion hits the lower front fascia cover and it forces the light to point slightly up with no way to adjust it down so they're aimed forward. I can't imagine a hot heat sink against a painted plastic surface is going to end up well either.
Second, the plug/lead is big enough that it can't be slipped through the gap between the bumper and the front fascia cover so it can be routed up behind the headlight and into the engine bay.
After I purchased it through a vendor, I discovered it'd been discontinued. You guys really should have pulled these back to the factory given the fitment issues. The instructions leave a lot to be desired as well.
The brackets were beefy and the light bar looked really well made as did the wiring harness minus the size of the plug on the light bar end. But the harness had all quality components.
Looking at the current offerings, there are no bumper mounted light bars in your lineup and it appears the newer light bars are an extra .25" in depth. The one below is allegedly 3.25" in depth. I didn't measure.
Time to start searching for a replacement!
Well Ford provided a bumper. It's up to manufacturers (like us) to make products that work. I can't speak for Zroadz but we designed our product to fit a few styles of light bars on there.
