Bronco Team 2 door.

[Lèòn]

Checked off three items on my monthly bucket list today

Sponsored

 

[Docindahouze]

I installed my trail rax roof rack this weekend. I bought it back in February and it sat for a while lol. I also have the pakrax lower bracket installed but left off the side panels until I need them. I also added my heretic lightbar as well as some lights on the side and two small kc light on the rear end. Wiring will be done soon. Still have to figure how I’m gonna route wiring to the engine bay. Thinking the simple thing would to go down the windshield even though it’s ugly lol. Eventually it will have an rtt on for when I go on trips.

 

[Lèòn]

It was a good day like Ice Cube sang

 

[Msell71]

My 71 that I had many moons ago.

And my 23 that I got in May.

 

[budman]

2023 Outer Banks Sasquatch.

 

[BEngland]

2D all day for me!

 

[Fortydegnorth]

Joining the 2 door crowd. Wife has a 4 door, so best of both worlds.

 

[OMTBiker]

This past week/weekend: Redline Maxlift hood struts, grille inserts (OuterBanks), Door pocket bags, and the big change was installing the Bestop Trektop yesterday.

 

[Mikey1287]

2D Wildtrak on the beach in the OBX.

 

[Gnomad]

Out on the trails in Luce county in da UP. Started out at paradise , found some mud and bad trails on the way to Cris Point lighthouse. The wifely one has the good pictures on her phone of course.

 

[telenerd]

Another weekend above 10k feet in South Eastern Wyoming. Kennaday Peak.

Trail wasn’t all that difficult but rocky at the top along the switchbacks!

 

[GWest2]

Just picked up after a 2 year wait.

 

[Squatch]

I think routing behind the A-pillar is the best bet. I quoted one reply but I know I saw someone do it from outside... couldn't find it, but good luck! Great looking Bronco

I installed my trail rax roof rack this weekend. I bought it back in February and it sat for a while lol. I also have the pakrax lower bracket installed but left off the side panels until I need them. I also added my heretic lightbar as well as some lights on the side and two small kc light on the rear end. Wiring will be done soon. Still have to figure how I’m gonna route wiring to the engine bay. Thinking the simple thing would to go down the windshield even though it’s ugly lol. Eventually it will have an rtt on for when I go on trips.

The Garmins along with the parking mode power supply isn't too bad to install. Maybe an hour to install, tops. There are two different supplies available. One which plugs into the OBD connector. The second you'd wire into a fuse tap (a bit more effort).



The wiring can be routed under the plastic trim without having to remove it (using trim tools). I wrap some tesa tap around the cable in a couple of places so that it wedges under the trim. Remove the hand grip. Pull the long cable from the fuse box. Up the A-pillar, across the top to the center (dashcam). A couple of mini fuse taps and a couple of crimps.

 

[Teke]

Few weeks ago I drove 2 hours west to hit up Badlands ORP for the majority of the day. Then drove 2 hours back east to grab my dad’s dirt bike carrier then another 2 hours east to get a new dirt bike then 2 hours west to home. It was a lot of seat time but well worth it!

 

[Teke]

Sponsored