If you saw my post in that thread, It tells you what you have to do to use the factory switch in your case...
So per what you show the wires for the Factory Fog light are in there, but do you have to tap into them or are they pre-cut thus ready to be connected?
I pulled them out of the harness, cut the pins off going to C203, and wired the connector directly to them... they only had a presence going into C203, they did not come back out.
You would think that Ford would have those wires sticking out from the harness, or maybe have a connector already on it especially if the Black Diamond was standard with the bumper that has fog lights. I would think that they would do it that way going down the assembly line with that wire harness and when the bumper was added either with the fogs or if it was optioned like mine with the MOD Steel Bumper, they could just tuck it out of the way covered with a cap or something. VS. a base model or something else that didn't have the fogs wiring harness added to begin with.
So I was able to get into my wheel well to see the harness. I don't see any wires that could be C192 unless the connector in my 3rd pic is it?
Yup, Your first 2 pictures are C203, The second picture does a good job of showing where you'll have to tap in.
So the C192 connector would be really tucked up in there behind the headlight from what it seems in the diagram. It looks like I would need to remove a lot of stuff like the headlight etc.Yup, Your first 2 pictures are C203, The second picture does a good job of showing where you'll have to tap in.
The third picture might be a connector for the active cooling flaps on the intercooler? Maybe follow the wires and see if they go there..
I don't have a picture of C192, cuz I don't have it, but it would be higher up, and more towards the driver's side than that. You should see a sheet metal tab with an open square hole in it that C192 would clip into if it were there.
Yes even the base has the connection for rear fog lights it’s under the rear drivers side tail light I tapped in there for my fog lights, as well as my license plate, light going to the tailgate.
I don't think that picture has C192 in it... Here's a picture I found with what I believe is C192 in it...
Ok I will look to see if anything is there on mine because I don't recall looking down the side that far left inside the wheel well. I will take some photos too.I don't think that picture has C192 in it... Here's a picture I found with what I believe is C192 in it...
On my Bronco, Even fully assembled, when I look up into the fender from under the front, I can see that tab where it would be..
Sorry, i really can't tell in your pic...They do look pretty close to the same!@zuke
can you confirm which wire is the yellow/orange? I can see the brown one but just want to make sure I tap the correct yellow. I think it's #2 marked in my photo but I want to be sure. #1 is thicker gauge than #2.
Ok where in relation to the C203 wire diagram view are the wires in the connector, on the bottom or top of the connector compared to inside the fender? Are they on the Top Side? I'm not able to really see higher up in there and I don't want to disconnect it just in case I mess anything up.Sorry, i really can't tell in your pic...They do look pretty close to the same!
It would be the one that traces back to pin 48 on C203...
It should also be the same gauge as the brown wire...
#2 does look more orange to me than #1 But computer monitors can lie
Top!Ok where in relation to the C203 wire diagram view are the wires in the connector, on the bottom or top of the connector compared to inside the fender? Are they on the Top Side? I'm not able to really see higher up in there and I don't want to disconnect it just in case I mess anything up.
