What did you do TO / WITH your Bronco today? 👨🏻‍🔧🧰🚿🛠

[AKBronc49]

Went and played on the lake ice - Big Lake, Alaska.

Little Abnb cabin near Talkeetna, AK.

Sponsored

 

[Dan66]

Installed my GoRhino E boards the Instructions were terrible and a waste of time
they do not know left from right and driver side from passenger side Gesh But The Boards Are Great fit is perfect and works well, I got it Done but throw the Instructions in the trash !
I am Very Happy with the end result and look on these, also the magnets work perfect and
no tapping into the wiring harness ! so no Issues down the road with Ford Wiring

 

[Sven]

Drove around checking snow depth and where/how we are dealing with it as we have run out of places to plow it to. So up up up is the answer.

 

[C00TER]

Hit a whoop section in the Hassayampa River

 

[taconic41]

Used it to bring home some 12ft. long pieces of soffit.

 

[Mike5681]

Got dirty at Southington Off-road Park

 

[AKBronc49]

Installed my GoRhino E boards the Instructions were terrible and a waste of time
they do not know left from right and driverside from passenger side Gesh But I got it Done
they work very well and are a perfect fit, but throw the Instructions in the trash !

Mine are arriving this week, pretty excited for them. They look good on your Bronco!

 

[JDoc92]

New Toyo’s and Everglade rims yesterday.

 

[joeb]

New Toyo’s and Everglade rims yesterday.

Wow! Tight Clearance. Bronco just fits!

 

[PrepVet]

I’m going to be driving it in another snow storm. This time with absolutely no electronics of any kind. Even the dash. But it starts and moves so we are headed home.

 

[UtahBrandon]

Homemade attic tray, additional small flat bar underneath for clipping radios, can be used with gear straps to hang straps, cords, air hose if needed.
Lined it with kayak deck mat to prevent slippage, waterproofing, rattles.
Used the Pura Vida traction board uprights.
It’s a shame it negates the top from being able to go fully down, but best I can measure it seems to do so would limit you to about a 8.5-9” wide tray.
I tried to remedy some of that headache with some RivNuts and quick-turn knobs to remove the shelf. No such magic for the uprights, as there is no room for them between the mounting holes and the vertical part of the brackets.
So it would take maybe 3 minutes with an Allen wrench to remove those as well.

Looks great! Let me know if you have any ideas on how I can redesign this to be more soft top compatible. All of my ideas seem to add a lot more complexity and cost to the design.

I might add slots to the mounting holes on the traction board brackets so you only have to loosen the bolts to remove them but other than that I can always use real world input.

 

[jcgcbns22]

Do your AUX lights also help land aircraft at night??

Teralume ICON driving lights. These are just shy of 15k lumens, beam 1.3km! Newer ones are even more powerful. They work great. Same price or cheaper incl. shipping than USA brands on offer for Bronco. JCG

 

[broadicustomworks]

Looks great! Let me know if you have any ideas on how I can redesign this to be more soft top compatible. All of my ideas seem to add a lot more complexity and cost to the design.

I might add slots to the mounting holes on the traction board brackets so you only have to loosen the bolts to remove them but other than that I can always use real world input.

Hey that would work!
Otherwise the only thing I see that would allow it is making the shelf almost useless at about 8.5-9” deep.
Slotted holes that slot over, then slide the bracket down would be the ticket.
Heck, I might do that to these after my trip is over and I have some time to think it over (measure twice, cut once).

 

[orion]

Drove it home from the Off Road Wrecker Games. Saw a lot of different terrain!

All in a days drive, 460 miles...

 

[Bubbbba]

Finished my Badlands Orange delete!

@ JCW did you use the marker on the yellow bungees on the seat backs as well?

How did you change the color of your seat stitching?

Finished my Badlands Orange delete!

@JCW did you use the marker on the orange bungees on the seat backs as well

Sponsored