Ha, same. Some of those holes didnt quite line up for me. Took some trial and error and back pain.Got the Zroadz slider steps on. Probably should’ve phoned a friend but my hydraulic shop stool made it easy enough.
Definitely took some muscle to get them right. I did have to grind one hole out a little with the dremel to get the last bolt to fit on the rear passenger bracket.Ha, same. Some of those holes didnt quite line up for me. Took some trial and error and back pain.
Planning on crawling back under in a week or two to make sure everything is still tight.
I need to do the same on the front passenger bracket. Much easier than risking not having the rear/middle square (again).
What’s protecting the painted hinge from the bracket? Rubber washers?Had the Texas Complete Bronco tailgate reinforcement kit installed on my 2 door ‘21 Badlands. Bracket was a good, clean design and well packaged for shipment. Powder coating and manufacturing was high quality.
Yes. No metal on metal at the attachment points.
Cant believe I missed this on the Ford accessories website. The product description says it keeps dust/dew out....would it be good enough for rain as well?I finally took the roof off my Bronco since I got the cockpit cover today.
Bummer. Looks like there are a couple other 3rd party options that are waterproof and cheaper. So I'll be going that route.
Do you mind sharing the part number? Thanks!
Have these verified before ordering.
