- Thread starter
- #1
So started my modular bumper Baja design install last night then came to a screeching halt when the Bolt and nylon lock but would not budge. Hand thread and then power tool until the bolt barely stuck out of the nut and then would not move. Tried hand wrench, table vice, etc. not budging… likely will have to cut off and source new hardware for that one…
anyway, I have two (4pod) squadrons and one duel sr1 for my modular bumper. I see that I can mount light bracket directly to the bumper but that wouldmake it stick out a bit and more prone to damage. I did buy the mounting plate but it is different that the bracket for one 4 pod and two 2 pods. Anyone have suggestions to n positioning on the bracket? There are three slots, 3 sections, and each area there play so I can adjust, which is great for universal and tweaking but I just would like some advice if you have done the same install…. Also, do you recommend pulling the front corner of the bumper off for install? Not sure what the tork size is on bumper screws, not included with tool bag. Thanks
anyway, I have two (4pod) squadrons and one duel sr1 for my modular bumper. I see that I can mount light bracket directly to the bumper but that wouldmake it stick out a bit and more prone to damage. I did buy the mounting plate but it is different that the bracket for one 4 pod and two 2 pods. Anyone have suggestions to n positioning on the bracket? There are three slots, 3 sections, and each area there play so I can adjust, which is great for universal and tweaking but I just would like some advice if you have done the same install…. Also, do you recommend pulling the front corner of the bumper off for install? Not sure what the tork size is on bumper screws, not included with tool bag. Thanks
Sponsored