Wiring Baja Designs Squadron LEDs

[CO_wildtrak]

I’ve picked up a pair of Squadron Pro pod lights for my A pillar and plan to wire them into AUX switch 3.

unfortunately, when I opened the box I found that I don’t have the upfitter harness and splitter that comes with the BD Bronco kit. I’m trying to avoid outplaying another $65 for the wiring harness, so my question is:

Can I cut apart the standard wiring harness to make an DIY upfitter harness? Or is this a really bad idea?

thanks in advance!

Sponsored

 

[Baja Designs]

I’ve picked up a pair of Squadron Pro pod lights for my A pillar and plan to wire them into AUX switch 3.

unfortunately, when I opened the box I found that I don’t have the upfitter harness and splitter that comes with the BD Bronco kit. I’m trying to avoid outplaying another $65 for the wiring harness, so my question is:

Can I cut apart the standard wiring harness to make an DIY upfitter harness? Or is this a really bad idea?

thanks in advance!

You are going to cut right before the relay. Tie in both powers and both grounds. You are then able to connect them to the aux switches on the vehicle.

Best,
Brahian

 

[4x4TruckLEDs.com]

I’ve picked up a pair of Squadron Pro pod lights for my A pillar and plan to wire them into AUX switch 3.

unfortunately, when I opened the box I found that I don’t have the upfitter harness and splitter that comes with the BD Bronco kit. I’m trying to avoid outplaying another $65 for the wiring harness, so my question is:

Can I cut apart the standard wiring harness to make an DIY upfitter harness? Or is this a really bad idea?

thanks in advance!

You can modify the harness that came with it. Check out our site at www.4x4TruckLEDs.com next time you need lighting, we make it REALLY easy for everybody

Here is our a-pillar harness. All plug and play:

https://www.4x4truckleds.com/crystalux-a-pillar-wiring-harness-2x-wp-2-pin-connectors-baja-designs/

Sponsored