Pre-wired for lighting

[Vegas desert dude]

When I ordered my Big Bend Sasquatch I missed the auxiliary switches when I placed the order. I was wondering can anybody tell me I know that I can't put the switches in after market without a whole lot of disassembly and wiring harness changes what I'm curious of is since I did not order them if the wiring is still there in the mirror pod light locations and if so is it accessible in the engine compartment or someplace else where I can bend tie into it to install switches or am I going to have to run wiring complete. I would also like to know the same for the top light bar area do these wires run down to the distribution block in the engine where I could tie and switches can anybody help me with this info.

Sponsored

 

[Shotsy]

I doubt they run extra wires if they don't have to. However, I don't know for sure.

https://www.bronco6g.com/forum/thre...talled-diy-writeup-instructions-photos.35388/