NEW Flashcal+ Bronco Support!

[CrystalRedTintCoat]

I’m a day late and a dollar short … how do I set e/thing back to stock? I think I need to start over again.

Each time I try to make Flashcal changes I get all kinds of errors … “your vehicle doesn’t have that setting” .. or I change something and it doesn’t stick … or my B/O speakers are gone or won’t return in the UI.

Sponsored

 

[Valhalla]

WOW! hopefully they give something free for the GEN1 genie pigs!!

 

[CrystalRedTintCoat]

I’ve been following this thread and have a question regarding the b&o system. I saw some screenshots that show that you can toggle on and off fake engine noise and noise canceling. Has anybody tried that and what were the results? Could you tell a difference?

I CANNOT tell the difference. I’m confounded by the ANC and engine noise settings and I do not hear one difference.

I /think/ the “Active Noise Cancelation” setting set to “Enabled” means that the ANC is disabled.

Likewise, I /think/ the “Fake Engine Noise” setting set to “Enabled” means that the fake engine noise is disabled.

Regardless of how it “works” I cannot hear a difference when these settings are enabled or disabled.

What’s more, I cannot figure out for the life of me how to set my speakers. I have B/O speakers but only some of the speaker regions in the truck (rear) will stay set to B/O. In the past only the front would stay set to B/O, but not any longer. And, the middle speaker has lots of options (Eg: speaker only, tweeter only, speaker and tweeter, none, and some other options if I recall — I’m not in front of the UI just now). Somehow that setting won’t stick either and now my parking sensor audible alerts are gone. At one point I got the center speaker to “stick” again (I forget which setting) but now it’s acting up once more.

At this point, I feel I ought to factory resetting everything and start over.

I sent support an email on 8/25 and I’m awaiting a response. Support has been VERY good to work with, I will say.

 

[Alassise]

Hello,

Just installed mine on my 22 Badlands Non-SAS. Sport mode is fun!. As far as the other settings everything I used worked flawlessly, so far. I do have some questions about some of the settings functions. I don't know what they do...

Engine Shutdown - Enable/Disable
Navigation in Motion - Enable/Disable
Power Point Timeout - Disable / 10m / 30m / 1hr / 75m / 3hr
Screen Config - 8-inch Landscape / 13.2-inch Lincoln / 13.2-inch Ford / 12-inch Landscape

Also, I thought that one of the functions available was to enable the turn signals to remain on during daytime driving? Is this gonna be available as an update?

Overall, I am very pleased with the functions provided. I am an apple/Mac product user, and getting a very old HP laptop to work with FORSCAN was risky as I am not to savvy programing stuff.

Sponsored