[How-To] Factory Bronco Speaker Replacement

[Mikey D]

If I am putting components audiofrog g60s
6.5 kick
Tweeter dash. I assume I need to run wire from kick to dash? Or can I reuse current dash wires and add crossover?

AMP and Sub? I'll check them out.

Sponsored

 

[mcinfantry]

AMP and Sub? I'll check them out.

I’m going to run mabett pods with kickers

I want to see how it sounds stock
Then decide on amp, and maybe sub…

I like ‘eye doctor’ tests… lol
Iykyk

 

[Mikey D]

I’m going to run mabett pods with kickers

I want to see how it sounds stock
Then decide on amp, and maybe sub…

I like ‘eye doctor’ tests… lol
Iykyk

Sounds like a plan. I upgraded dash with JBL 421F and tryed rear with SSV Pods JBL Club 622. Fiddled with Forscan. Still sounded like crap. Working on an AMP solution with different speaker options.

 

[RagnarKon]

If I am putting components audiofrog g60s
6.5 kick
Tweeter dash. I assume I need to run wire from kick to dash? Or can I reuse current dash wires and add crossover?

The factory wiring runs to the kick panel first, and then daisy chains off the kick panel to the dash speakers.

So if you were going to run components, putting the crossovers by the kick panel speakers would be the perfect spot. You'll have to create some tiny jumpers from the factory wiring to the crossovers, but that's it.

There isn't a gigantic amount of room down there, but as long as the crossovers aren't huge you should be able to make it work.

 

[sleidel]

If anyone is looking for the Sub box with the Kicker key 500, Kicker sub, and bass knob I am selling mine. DM me if interested. I have all of the stock speakers as well. Looking to get $500

 

[Darth Rager]

For the dash speakers... yes it is still recommended... because they share their audio signal with the kick panel speakers (they are on the same channel).

For the rear pod speakers, no, it isn't necessary.

Can you recommend a harness to replace the Hoel Wiring Bronco/Maverick Speaker Harness? It does not seem to be available anymore.

Sponsored