Search results

The DV8 bracket interferes with the OEM mounting bracket behind the frame horn. No matter which way you try to position the DV8 bracket, it gets in the way and will not mount flush into the frame. Which reminds me, I still have the DV8 bracket, I went with Maximus 3 since they explicitly say it...

They told me it was leaking fluid. Apparently it's not up to them, Ford's recommends replacing the entire thing

Forgot to add an update, but thankfully it was all covered under warranty. The part was backordered so it took about a week for it to come in and get swapped. Thankfully I didn't have to pay for this out of pocket

Thank you, this gives me hope

Forgot to mention that I have an appointment on Monday

This randomly popped up on my way to Walmart. Checked under the skid plate and the connections and wires look clean and undamaged. The reason I'm worried Ford might not warranty this is because I installed eibach coil overs and 37-inch tires (two months ago), I also used forscan to correct the...

Over 3,000 miles (FL → CA). At the time, it was one of the few, new reasonably priced MT Broncos that was actually sitting at a lot and I didn't have the time to wait months to order one. Took a flight there with two other friends that knew how to drive stick and very quickly put over 3k miles...

Finally got around to installing the frame horn reinforcement kit and wiring the winch to the bronco

Installed the Maximus frame horn reinforcement kit and finally wired up my winch to the aux panel

For DV8? Only thing I got was just the brackets and bolts

Shoot me a PM and we'll go from there

I thought the zone UCAs didn't come with ball joints so bought extra. Was going to throw them out but figured maybe one of you guys might want it. I also removed the shocks via the lower control arm method, so I didn't end up using the axle hub nuts either so you can have them as well. I'll ship...

Also installed gearshade limb risers. Power coated the brackets.

Found a good deal on take off sas fender flares

https://www.amazon.com/dp/B0FZJM7FDM?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1 Here you go. So far I'm liking the reinforcement. I'm pretty sure it's the same one mabett, bucket up offroad and other drop shippers are using.

for both the reinforcement and brake light relocator?

you got a link to those terminal caps?

You got a link to those terminal caps?

Just curious did you install frame horn reinforcements?

Installed the rough country high winch mount along with the rough country camera relocation kit. I haven't wired it up yet, still waiting on a 2ft positive wire to hook up to an isolator