Search results

Quick update - the dealer kept my Bronco for about a week and a half using every vibration sensing and runout tool they had to figure out the driveshaft needed to be replaced. After they replaced it, the vibration went away. It looked fine to me, and it looked fine to them, but replacing seemed...

I've been noticing this lately too. Mine's right around 50MPH. It's certainly not a wheel balance issue because the frequency of the vibration is too high. It kinda reminds me of the lane keeping vibration, but it's not as strong as that. And the lane keeping vibration pulses three times...

Gosh, I just had the TSB done and I was pretty frustrated with the dealer until I read this thread. Now I’m really grateful that it only took 15 days to get it back. They originally thought it might take as little as a couple of days, but it took several days just to get to it and then they...

Good question! I have not changed anything yet. Here’s my plan: I want to find the driver’s door module and the passenger door module under the dash. I think that if there is enough room to add a diode inline with the output of each module, that would be ideal. They’d be out of the weather and...

I’ve seen some great materials at a couple of Walmart automotive sections lately. I think I would buy the butt connectors, primary wire and even this compact (and inexpensive) heat gun there if I were starting this project without any materials...

Ford can’t let the mirror spots stay on under motion (above 6mph in this case) because the mirror spots are not DOT approved. They don’t have a horizontal cutoff to prevent direct light going into the eyes of other drivers. However, this is a discussion of off-road auxiliary lighting, which most...

EDIT: I found the culprit. When I was exploring Zone Lighting options, I must have switched this...but now that I have it disabled, my error code went away: __________________________________________________________________ (Original message) I've searched everywhere and I can't seem to...

I rented a 2024 Nissan Rogue on a recent business trip, and the subtle fake sounds coming from the speakers sounded like either a V12 racecar engine or a sportbike. (It has a 1.5L three cylinder engine, so maybe the sportbike-like sounds makes a little bit of sense.) Anyway, I really appreciate...

FINAL edit: I’m changing my mind about this circuit- After plenty of feedback and my own experience, DIODES ARE NOT NECESSARY in my opinion. You can follow all of these steps and LEAVE THE DIODES OUT if you want to. __________ Original post: I also had the same concerns about powering the...

Parts list: Cheap brackets https://www.amazon.com/dp/B0BPP6KX7Z?ref=ppx_yo2ov_dt_b_fed_asin_title I want to make something clear though - These brackets are not the highest quality. You DO get what you pay for. When these brackets start rusting on me and causing problems, I will very likely...

@flip, you’re a kind gentleman for offering us all a discount. I will set up an account soon. I currently have a -HC style switch since I have spots and puddle lamps but no fog lamps in my Badlands High w/modular bumper. Do you know if a person could buy a -AC switch and swap the bezel with...

So far, it seems like the nearest OHV park is Wildcat, an hour and a half down 75. But if I find a place closeby that we could use to “see if our lockers work “ I’ll post it here

Hey folks, I just finished my install on my 2022 Badlands Sasquatch w/MT. It all went well. My couple of suggestions are: Even with 35" tires, you don't need to remove the wheels but jacking up the driver's side helps a lot. Especially if you have the swaybar disconnect and you use it before...