No updates at the moment. The bronco bumper sales are not high enough to justify the R&D at this point. way too many people want "cheap" parts and we refuse to make crap. The cheap Import parts have flooded this market. Amazon Armor for the people that want the off road look but never use it...
Our Black November sale is live. So if you have been on the fence now is the time to order. Up to 30% off ends the 30th.
https://www.bayareametalfab.com/6th-gen-FORD-BRONCO_c_37.html
The parking sensor holes are cut for these grommets.
the grommets with the large indexing tabs would need to be shaved they still clip in place and hold better than rubber grommets . Or these could be ordered from FORD and the factory grommets can be left in the factory bumper.
A lot of...
Running 33s with a +30 offset. Will this fit or is it 35+? Yes 33's have plenty of clearance
Any option for black bolts/washers or anyone know the size? We actually just received our custom black oxide coated SS flange bolts. The washers are grade 8 yellow zinc.
Assume the issues discussed...
I'm In the long process of updating our instructions in new software.
The parking sensors need to be re-loomed. Take all the tape off the wire loom run your wires around the back of the bumper and re-loom the wires once you have the new routing. There is just enough wire to run out the back of...
I'll have the pictures on the site updated this week. We're shooting some once the Molle panels are coated today or tomorrow.
This is a completed rack.
All the racks without Molle panels on the order shipped out yesterday. Molle rack orders will be shipping the end of the week.
There was a copule racks shipped without some of the hardware. So if you received another tracking email today that's what that is. They should beat the racks to most...
The manufacture only sells in 55lb boxes. we have a touch up pack on our site.
https://www.bayareametalfab.com/BAMF-Powder-Coat-Repair-Powder_p_84.html
Yes absolutely, You can coat whole parts if you have a way to evenly apply it and get the parts to temp. We have a Industrial Heat gun (Shrinkfast 998) and I've coated large parts with it . A hand held MAP gas torch or high end heat gun you could repair a 10x10 area at once to look nearly...