Sponsored

Search results

  1. Apex Compact Reel System Mount

    Any ideas on locations under the hood for mounting? I’m not interested in a roll bar mount, and want to keep it all in the engine compartment. I have a Grimm Off-road compressor mount. Also, I have an American Adventure Labs battery cut off switch and bracket mounted above the firewall on the...
  2. Inverter recommendations

    What works well and lasts a long time? Feel like Redarc 1500w is the best option, but it’s also 2-3x the price of the competition. Reviews on other devices have me scared about reliability. Need to power a 1200w induction cooktop.
  3. Ignition wire for BCDC Charger

    Just installed a BCDC 40A and a DCS 100Ah slimline battery. BCDC requires the blue switch wire to connect to an ignition wire for vehicles with smart alternators, and I assumed I could use an upfitter switch for that purpose. Long story short, that didn’t have the intended effect. What do I...
  4. DCS 12v 100AH Super Slim Deep Cycle Lithium Iron Phosphate (LiFePo4) Battery

    Anybody use this? Stopped by Rhino in San Marcos looking for advice/solutions for battery mounting. This is pretty expensive, but opens up a lot of doors for saving space. I’m thinking about mounting it to the back of the rear seat on the driver’s side. It will fit perfectly in that location...
  5. Low profile recovery gear storage

    I’m looking for a low-profile box to mount on my PackRax to store my recovery gear. This will free up space in the cargo area, as well as keep my interior clean from dirt acquired via off-road recovery. Most overland-type boxes are far too big for this configuration. Looking at pelican cases...
  6. Mud everywhere

    I normally avoid mud because of the pain it brings for months afterwards. Having said that, I’ve driven many vehicles through very muddy situations, and never seen anything like how badly the Bronco gets caked in every single crack and crevice. I had to hit a single muddy spot on a trail back in...
  7. HF Radio Install Considerations

    Looking at upgrading my ham license to play on HF frequencies. What are things I need to consider when installing a mobile HF radio in a Bronco? how does the mix of steel and aluminum panels impact grounding and noise? I have an aluminum roof rack (TRMR) - is that a suitable location for an...
  8. Stuck in 4x4 - Dealer/Ford can’t diagnose, 6 weeks and counting

    A couple weeks ago, I got a “Check 4x4” message and Powertrain warning indicator when starting my Bronco in the driveway. I fiddled around with the controls for a minute, and then shut it off before starting it up again. This seemed to clear the fault, and I went on my way. then, last week, it...
  9. Battery and solar

    I’ve got an EcoFlow Delta 2, and am curious about how to run charging from both solar and the alternator. I would like to put a panel on the hood and a panel on my SkyCamp 2.0 - there are panels custom cut for both of those. What’s the best way to run power? My goal would be to keep my...
  10. Compressor questions - pressure switch, tank locations

    Looking at putting an ARB twin in my Bronco. Would like to also mount an air tank. questions related to this: 1) Where are Good locations for mounting the tank if I do an under hood mount for the compressor? It looks like I could fit a small tank under the body, just forward of the rear diff...


Top