Search results

Installed this lamp right behind the tail gate window, attaching it to the Hard Top Rear Cap Trim Cover. Ran the wires behind the tailgate window seal and over to the courtesy lamp. The hardest part was getting the courtesy lamp out of the side panel. Worked great and now I can see in the cargo...

I have a 22 OB 2.7 AT. I would get a hesitation when taking off from a stop sign when the engine was cold. I installed the ProCal Tune and it hasn't happened since.

Does your Bronco have Standard, Mid, High or Lux package?

I never did the reset. Replaced sensor and the temp appears correct on the info center. Not saying it doesn't need resetting as this may affect something besides what the outside temp shows on the Info Center. I think the engine may also use this sensor. No error codes pertaining to the sensor...

I'm researching the installation of the Wolfbox before I make the purchase. I'm also concerned about error codes. I have a 22 Outerbanks with Lux Package with the second mirror listed. I gather 2 others have the same mirror with no error codes and you are getting error codes. Could it have...

Ditto. I have not changed my timeout length but for the last 2 months the rear 12V powerpoint was immediately turning off once the Bronco is turned off. Dealer replaced the battery today and the rear 12V powerpoint is now active after turning off Bronco.

The sensor is on the bottom of the drivers side rearview mirror assembly.

Merry Christmas to everyone.

I'm running the original size RokBlokz which are smaller and narrower then the XL and XL long.

I had planned to purchase the Mongoose and pay as needed the FJDS License (2 day). So where would I get the correct configuration file for a 2022 Outbanks with Advanced 4X4, Automatic Trans and Sasquatch? I'm thinking I would need a VIN to use. My other thought was to get the AWD Module from a...

Hi Jeremy, Today I spent some more research time and found that the AWD module that I have may not support the Front Locker. Ford Part Number MB3Z-7P238-E For Open Front Axle (my Bronco) Sticker Part Number MB3A-7P238-GA H/W MB3P-14GF581-BA Ford Part Number MB3Z-7P238-D For Front Locker...

Installed the latest version of AC Fab Links today. The stock ones were making clunking sounds. These are the latest version with Upper Studded Heims. Lubed with Tri-Flow Superior Lubricant Spray. Quiet as a mouse. Oscar was very helpful during the ordering process.

Did you try the Ford Performance ProCal Tune? When I did the Ford Performance Tune ProCal asks if you have upgraded to the M210. I planned to tell Procal I now have a M210 and was hoping it would configure everything.

How did you try to make it work. Parts, Procedures, using Forscan or ProCal?

Thanks, I may go this route using this pigtail and get two terminals for the C1137 connector at the other end of the stock wire harness instead of buying the whole harness. Wanted it to look as if it came from the factory.

I have the 22 OBX 4DR 2.7L LUX Package with Advanced 4x4 (No FAD) and M190 Front Differential. Putting together a list of parts needed to install a M210 and integrating this into the GOAT system. Have also purchased the Ford Performance ProCal that allows me to change from the M190 to the M210...

According to the Service Manual, after replacement of sensor, "Using the diagnostic FDRS scan tool, follow the on screen prompts to run and reset the outside air temperature sensor learned values." I don't have FDRS to do this. Replaced my sensor that was stuck at 63 degrees. The new sensor...

Can you give us a link to this part "sway bar link extenders from extreme terrain"? Is your sway bar OEM? Thanks

My temp was reading low. And would stick around 63 or 64 and start working again after driving around. Replaced sensor yesterday morning and it appears to be working like new again. Most people with issues are saying that their temps are showing higher, only saw a few people saying their temps...

Yes, I have a warranty but the dealer is 3 gallons of california gas round trip. My dealer has been pretty good at getting me in and out.:)