Search results

15. Amp and subwoofer.

I have one that I’m looking to take off and replace it with the cover.

Are you still looking for a handle?

so there are Bronco options...on homepage select the 2020+ Bronco vehicle and it will take you to the various kit options. Secondly, do you have base audio or B&O. Base is supported with PNP, not B&O yet. Then you have to decide what amp or other options you want, sub, LCI etc. Then you go...

Yes, there is a harness you can purchase from www.plugnplaykits.com

“Version”

Also, for you MT drivers, there is a different fire wall location to run the power wire through as the larger rubber grommet from the AT Verizon is taken up by the clutch. A small cover can be poked out and a new rubber grommet installed to protect the wire from chafing.

I looked at that and found it too tight for the steering wheel to move about.

Added my Kicker Key 200.4 amp to my new speaker system! Much bettah! Hid it in the glove box.

One idea I had for placement of the Kicker Key 200.4 amp was in the glove box. Worked out well and had room for the Plugnplaykits harness over the top of the box. Out of site yet accessible if necessary. Truthfully I could not reach up further to figure out how the OP did it nor the patience!

I figured out what I did wrong…had the source selection on phone vs usb and also wasn’t playing the noise before I started the test. I thought the amp ran the whole thing. Duh.

Did you have the radio on when you did the pink noise and at what level was it at? I've tried the USB stick multiple times and still get the sad music and 4 beeps (pink noise and audio level error.) Thanks.

What did you use to play the pink noise? A USB connection with a memory stick or through your phone? I keep getting error 4 with my set up. Thanks.

Excellent. Would you be able to pull back a bit for another pic? Hard to see the perspective of the sub’s location. Thanks!

Well, at this point, we are all World Series bound!!

I don't know what it takes to make one with your printer but I'd be interested in buying one. Going to test it out on my install if you can. If not, I'm going to head to HD and see what I can gin up. I like the concept a lot!

well done! you should sell those brackets!!

You've got the heater vents right in the middle of the space. Might consider hanging it from the molle that is part of the tailgate table from JCR...another person shared that option.

Do you have a pick of how it’s attached to the bracket and wall? Thanks

Love that idea. I have the same sub to install and like this idea. Do you have a pick? What type of bar did you attach to the molle? Thanks