Sponsored

Search results

  1. Michigan Roll Call

    I go to Barber for my parts & service, but that's about it. Congrats on the status change.
  2. Beadlock Rings Powdercoated Race Red

    Where in MI are you and where did you have it done at?
  3. MontyMoose

    Michigan Bronco Club

    If only it were a 4-door... I'd have traded you my rock rails for your side steps.
  4. MontyMoose

    Michigan Bronco Club

    I saw the post on the OTHER forum about the "Official Bronco Corral" on the 21st (limited to 250 Broncos), but unfortunately my work schedule conflicts with it.
  5. Front license plate mount options?

    I have an FE with the MOD.
  6. Front license plate mount options?

    Only thing I had to do was expand the bracket a little bit to be able to get the rubber friction washers between the shackle mount and the bracket. No drilling needed.
  7. MontyMoose

    Michigan Bronco Club

    Is the Pin Map of all reservations, BroncoNation Members, or just everyone that went to the Off-Roadeo so far?
  8. Gremlin / Reported Issues Thread

    Mirror and/or grille whistle
  9. MontyMoose

    Michigan Bronco Club

    @McCracken The hardest part was pulling out the little clips on each side that hold some wiring. Tried doing it without pulling one out and just couldn't do it, but once it was out, the bracket bolted in easy peasy. The whole process SHOULD take about 10-15 minutes from start to finish (I took...
  10. MontyMoose

    Michigan Bronco Club

    @ScoutandBronco Yeah, I stopped by Red Wok for lunch.
  11. Hood Struts Kit For 2021 Bronco (Available August 1st from Redline Tuning)

    Hood closes smoothly, no issues whatsoever.
  12. MontyMoose

    Michigan Bronco Club

    First couple minor mods arrived and have been installed. Not sure what else I'll be doing to her, but these are a good start. Redline Tuning Hood QuickLIFT Elite hood support struts Kentrol Shackle Mount Front License Plate Bracket Submarine Warfare Vinyl Decal (Not pictured The Stubby...
  13. Hood Struts Kit For 2021 Bronco (Available August 1st from Redline Tuning)

    Received mine today (ordered on the 23rd), and 20 minutes later had them installed. Hardest part was pulling out the clips for the wiring harness which gets in the way when reinstalling the bolt & bracket.
  14. Front license plate mount options?

    I also went with the Kentrol bracket and use the upper left (as you look at it) set of holes. Might change it to the upper center holes later though.
  15. How's the wind noise at 70-80 mph with hard top?

    While definitely louder than my F-150's cabin, it's not overwhelming. The radio (I have the B&O in my FE) is more than loud enough to be heard, and there's no issue with having conversations.
  16. MontyMoose

    Michigan Bronco Club

    @ScoutandBronco I saw Preferred Ford in GH got their mannequin a couple days before mine arrived (and so did half the guys I work with that drive past there on their way into work), but you couldn't pay me to use them after they effed up an oil change on my 2011 F-150. Has yours arrived yet?
  17. MontyMoose

    Michigan Bronco Club

    @ScoutandBronco I'm over between Holland and Grand Haven. I went with Fox Ford over in GR.
  18. MontyMoose

    Michigan Bronco Club

    Yeah, still trying to hit that lotto jackpot to pay it off early though!
  19. MontyMoose

    Michigan Bronco Club

    So far so good... no mirror whistle on mine! 🤞


Top