Search results

Hello I had some paint done to the rear hatch but the bronco was not reapplied. Would anyone be willing to give me measurements of theirs. My OCD doesn’t allow me to just stick it on! Thanks in advance

I used the @Fast Intentions Inc. ditch light mounts and wired up some BD LP6s they look amazing! Just do it!

Looking for a plug a play option to wire 6 light pods to my oem fog light switch. I'm aware i'd have to use a relay to pull power directly from the battery but would like to not have to cut up my oem fog light plug. Anyone made their own or know of a vender selling something similar?

How bad was it dented? I had something very similar happen today. I have a very small dent but noticed the tailgate outer skin has a bit of additional flex on the right side between the mounting brackets to the hinges when I push on my tire with force. I was planning to just have the PDR try to...

You can turn this off in forscan… the fake engine noise is very noticeable.

I need this 😇 does yalls harness also tie into the reverse light or just the up-fitter switches?

I'll be ordering the rear tire chase mount soon!

So I’ve been wanting to install some LP6s on my A-pillar for a while now. I was so close to mounting them straight to my mounting point on the cowl but glad I waited. I went with the @Fast Intentions Inc. A-pillar mount which turned out amazing. I will get some photos tomorrow during the day. I...

I hope this will make it easier to retrofit a 12” cluster in a 23. I was going to opt for the raptor cluster but hate that not all the Wildtrak goat show up.

Ordered! Thank you. Looking forward to mounting up my LP6s.

I’m going to need these! Was looking for a mount that would work with the LP6s.

Do you lose any functionality over OEM like auto high beams or anything get trigged on forscan for errors since it won’t detect the oem lights?

Where are you located and how much are you asking if they are still available.

I’m interested in mounting some LP6’s to my a pillar anyone else gone this route? Looking for the best mounting option.

I’m interested in this swap would anyone know what the part numbers are for the raptor headlights?

I ended up using the smaller grommet right above the main one on the firewall. Popped it out and cut it.

Thank you I was looking for a possible grommet on the driver floor. I’m about to go check it’s just 100 degrees in Texas and the concrete is not my best friend right now lol.

Hello I’m looking to install an Opt-7 underglow kit and wanted to see if anyone has used an existing grommet on the floor board to access the cab nearest to the driver. I’m prob going to go with and add a fuse on the interior fuse panel on fuse #2. Any help would be appreciated.

Did this cause any issues? I'm looking to connect a trigger for some led courtesy lights/under glow.

@drvahe would you be willing to make one of these for me to buy from you? I'm looking to add a outside courtesy lights and this would work great... unless you can recommend a better place to grab the puddle light trigger.