Search results

Great write up! For those on the fence about blocking the sub port I can't street enough how important it is. It makes a huge difference!

Just wait until you hear the morels if you think those Hertz sound amazing. It will ruin any other Stereo! Make sure you wipe the Hertz tune out

Yes a video was made last week actually! Will be out soon. Thank you to all that offered

I have heard a whole bunch of different subs in the bronco and I would say the morel is hands down the best. The stinger has the best output for $ ratio though, its cheap for the doof you get. Both hit significantly harder than the Sealth box

Im honestly not sure at this point, i could see a bunch of issues on the RTA. But i see the same dip at 70hz in all Bronocs and most subwoofers. Hard to say without me hearing it

Ive done all I can. I think the issue is the Stealth box with a TW1 is just an underwhelming sub.

You can cut that connector off. Some sub boxes have it done don't, if you don't just cut it off and wire directly to your sub

Yes the Hertz are a good pairing to our amp. I always recommend swapping all speakers out. What i meant was if i was trying to save money and get the best results the setup before would be what i recommend. If budget permits, you should swap all speakers! We have a tune for the those Hertz...

Best bang for buck sound improvement if you're on a budget is swapping the amp with ours, subwoofer that handles 400w RMS @2 ohm and kicks with something that handles atleast 100w RMS. The B&O speakers across the dash don't sound too bad when tuned right. This setup will give you a night and...

The B&O amp is pushing 25w RMS to the kick locations. The B&O speakers are pretty sensitive and built for that power. In some cases swapping the kick speakers out without adding amplification can result in a worse sound than leaving them. Bottom line is the B&O amp is rubbish and needs to go!

https://www.morelhifi.com/en/dealers

It's not available through our website. It's available through your local Morel dealer.

@GearShade are actually working on a box that will fit our amp!

You will need a change over amp unfortunately, there was a batch of amps that had this issue. Please PM me and we will organize a swap over. Anyone else experiencing this please contact me for a warranty amp

The center channel is not driven by the B&O amplifier. it is driven by the ACM

The ACM powers the rear pods and the center channel. Hench the ACM harness, this runs these back for our amp to power The kicks and dash speakers are driven independently from the amp in the rear.

Sent you a PM

That looks fantastic! Ive just emailed you.

@GearShade Given your boxes are 3d printed. If we sent you a full CAD model of our amp could you add its mounting holes as an variant? Excuse my ignorance if it is more complicated than that.

I knew you would love the setup!